Index Interfurn 90-823226 manual Reservoir Cap Vent

IMPORTANT: A two-way valve is required on the reservoir cap for cold weather operation below 40°F (4°C).

6.Secure hoses with Sta-Straps to keep them be- low reservoir fluid level line and away from heat and moving parts.

3.If required, install two-way valve in reservoir cap by removing vent from cover and replacing it with a two-way check valve.

b

a

72855

d

b

c

ea

72857

a - Reservoir Cap

b - Vent

b

a

72856

a - Reservoir Cap

b - Two-Way Valve (Installed)

4.Cut two hoses (from bulk hose supplied) of suffi- cient length to extend from bottom fittings on res- ervoir to fill caps on power steering pumps. Allow extra hose for routing.

IMPORTANT: When routing and installing hoses in the following steps, be sure that the bend ra- dius in the hose is sufficient to eliminate a load being placed on power steering pump fill cap.

5.Connect hoses, that were just cut, to reservoir and power steering pump caps (from kit). Secure with hose clamps. Tighten securely.

Index

a- Power Steering Pump Cap (Port and Starboard)

b- Hose To Reservoir

c- Hose Clamp

d- Sta-Straps

e- Bend Radius (Port and Starboard)

a

b

c

b 72858

a - Reservoir

b- Hoses From Pumps

c- Hose Clamps