NOTE: Engines with power steering are equipped with a hose that is connected to the power steering fluid cooler. A fitting on the other end of the hose would normally be connected to the power steering control valve. These hoses are not used and are replaced with bulk hose supplied with priority valve kit.
4.Remove and discard old (control
5.Cut two hoses (from bulk hose supplied) of suffi- cient length to extend from power steering cool- ers to respective fittings on priority valve.
6.Connect one end of each hose to its respective power steering fluid cooler and other ends to fit- tings on priority valve. Secure with hose clamps. Tighten securely.
b
c
a
72588
a- Power Steering Fluid Cooler
b- Hose
c- Hose Clamp
b
c
a
c72862
b
a - Priority Valve
b - Hose
c - Hose Clamp
7.Install return hose (large fitting on one end only,
Index
from kit) to power steering control valve. Route hose to priority valve, cut hose to length, and con- nect to fitting on priority valve. Secure with hose clamp. Tighten securely.
a
b
72863
c
b
a
72864
a - Priority Valve
b - Hose
c - Hose Clamp
POWER STEERING - |