Graco 334014A Fire and Explosion Hazard, Pressurized Equipment Hazard

Page 5

Warnings

Warnings

The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this manual where applicable.

WARNING

FIRE AND EXPLOSION HAZARD

Flammable fumes, such as solvent and paint fumes, in work area can ignite or explode. To help prevent fire and explosion:

Use equipment only in well ventilated area.

Eliminate all ignition sources; such as pilot lights, cigarettes, portable electric lamps, and

plastic drop cloths (potential static arc).

• Keep work area free of debris, including solvent, rags and gasoline.

• Do not plug or unplug power cords, or turn power or light switches on or off when flammable fumes are present.

• Ground all equipment in the work area. See Grounding instructions.

Use only grounded hoses.

Hold gun firmly to side of grounded pail when triggering into pail. Do not use pail liners unless they are antistatic or conductive.

Stop operation immediately if static sparking occurs or you feel a shock. Do not use equipment until you identify and correct the problem.

Keep a working fire extinguisher in the work area.

Route exhaust away from all ignition sources. If diaphragm ruptures, fluid may be exhausted with air.

PRESSURIZED EQUIPMENT HAZARD

Fluid from the equipment, leaks, or ruptured components can splash in the eyes or on skin and cause serious injury.

Follow the Pressure Relief Procedure when you stop spraying/dispensing and before cleaning, checking, or servicing equipment.

• Tighten all fluid connections before operating the equipment.

• Check hoses, tubes, and couplings daily. Replace worn or damaged parts immediately.

334014A

5

Image 5
Contents Repair/Parts manual. Save these instructions Important Safety InstructionsRelated Manuals ContentsOrdering Information To Order Replacement PartsTo Find Your Nearest Distributor To Specify the Configuration of a New PumpConfiguration Number Matrix Pressurized Equipment Hazard Fire and Explosion HazardThermal Expansion Hazard Plastic Parts Cleaning Solvent HazardEquipment Misuse Hazard Personal Protective Equipment Toxic Fluid or Fumes HazardBurn Hazard Tighten Fasteners Before Setup InstallationMounting GroundingAir Line See Typical Floor Mount Installation,KEY Air Exhaust VentilationFluid Outlet Line Fluid Supply LineFluid Inlet and Outlet Ports 1050HP Aluminum ManifoldsTypical floor mount installation Typical Floor Mount InstallationOperation Pressure Relief ProcedureFlush the Pump Before First Use High/Low LeverPump Shutdown Start and Adjust the PumpMaintenance Schedule MaintenanceLubrication Tighten Threaded ConnectionsTorque Instructions Aluminum Dimensions and MountingSST Aluminum and SSTLow Pressure Setting Fluid Pressure Performance ChartsHow to Read the Charts Air ConsumptionHigh Pressure Setting Technical Data Fluid Temperature Range Fluid Temperature RangeWetted parts Non-wetted external partsGraco Information Graco Standard Husky Pump Warranty