Graco 334014A Typical Floor Mount Installation, Typical floor mount installation

Page 12

Installation

Typical Floor Mount Installation

Figure 3 Typical floor mount installation

KEY

AAir supply line

BBleed-type master air valve (required for pump)

CAir filter and regulator D Air inlet

JFluid drain valve (required) K Fluid shutoff valve

LFlexible fluid outlet hose

MFluid inlet (2 ports on aluminum manifolds,1 port on SST manifolds)

EMaster air valve (for accessories)

NFluid outlet (2 ports on aluminum manifolds,1 port on SST manifolds)

F Flexible fluid suction hose

R Ground wire (required; see

 

Grounding, page 8 ).

GOptional needle valve for pump speed adjustment.

12

334014A

Image 12
Contents Important Safety Instructions Repair/Parts manual. Save these instructionsContents Related ManualsTo Order Replacement Parts Ordering InformationTo Find Your Nearest Distributor To Specify the Configuration of a New PumpConfiguration Number Matrix Fire and Explosion Hazard Pressurized Equipment HazardPlastic Parts Cleaning Solvent Hazard Equipment Misuse HazardThermal Expansion Hazard Toxic Fluid or Fumes Hazard Burn HazardPersonal Protective Equipment Installation Tighten Fasteners Before SetupMounting GroundingSee Typical Floor Mount Installation, Air LineAir Exhaust Ventilation KEYFluid Supply Line Fluid Outlet LineFluid Inlet and Outlet Ports 1050HP Aluminum ManifoldsTypical Floor Mount Installation Typical floor mount installationPressure Relief Procedure OperationFlush the Pump Before First Use High/Low LeverStart and Adjust the Pump Pump ShutdownMaintenance Maintenance ScheduleLubrication Tighten Threaded ConnectionsTorque Instructions Dimensions and Mounting AluminumSST Aluminum and SSTPerformance Charts Low Pressure Setting Fluid PressureHow to Read the Charts Air ConsumptionHigh Pressure Setting Technical Data Fluid Temperature Range Fluid Temperature RangeWetted parts Non-wetted external partsGraco Standard Husky Pump Warranty Graco Information