Transom
Transom |
Position transducer mount on transom and mark mounting holes.
Side view shown at left and seen from above at right.
5.Attaching transducer to transom. Remove the transducer from the bracket and
Route cable over bolt and through bracket. Side view shown at left and
seen from above at right.
Attach the transducer to the transom. Slide the transducer up or down until it's aligned properly with the bottom of the hull as shown in the preceding and following figures. Tighten the bracket's mount- ing screws, sealing them with the caulking compound.
Adjust the transducer so that it's parallel to the ground and tighten the nut until it touches the outer washer, then add 1/4 turn. Don't over tighten the lock nut! If you do, the transducer won't
Bottom
of
hull
|
|
Align transducer centerline with hull bottom and attach to transom.
10