Furuno B042-004, B042-016, B042-008 manual Water Temperature Sensor Setting, Temp Setting menu

3. INITIAL SETTINGS

d)Use [+] or [-] to set the value for the frequency which is connected, and then press [!] or ["] to close the dialog box. (Available range: HIGH; 40 – 220 kHz, LOW; 25 – 220 kHz)

e)To operate the transducer in reduced power (for example, when vessel is in dry dock), press ["] to select PWR REDUCTION, and then press [+] or [-] to open the dialog box.

OFF ON

f)Press [+] or [-] to turn the power reduction ON, and then press [!] or ["] to close the dialog box.

6.Confirm settings and turn off the power.

3.3Water Temperature Sensor Setting

If a water temperature sensor is connected, set up as follows:

1.Turn on the power and turn the [FUNCTION] switch to the MENU position.

2.Press [!] and [+] to select SYSTEM at the top of the screen.

3.Press ["] to select TEMP SETTING, and then press [+] to open that menu.

DISP ALM TX/RX E/S SYSTEM

TEMP SETTING

TEMP UNIT	:	˚F
TEMP INPUT	: SENSOR
TEMP ADJUST	: +0.00˚F (-20 +20)
TEMP OUTPUT	: OFF
TEMP READOUT	: OFF
TEMP GRAPH	: OFF
TEMP COLOR	: STD

Select temperature unit.

[-/+]: Change set, [EXIT]: Exit

TEMP SETTING menu

4. The cursor is selecting TEMP UNIT; press [+] or [-] to open the dialog box.

CF

5.Press [+] or [-] to select the temperature unit, and then press [!] or ["] to close the dialog box.

3-7