Furuno B042-016, B042-004, B042-008 manual Damage to the transducer may result

Page 4

CAUTION

Ground the equipment to prevent mutual interference.

Observe the following compass safe distances to prevent interference to a magnetic compass:

	Standard	Steering
	compass	compass

CV-1100L	0.7 m	0.5 m

Do not allow warm water or any other liquid other than seawater or freshwater to contact the transducer.

Damage to the transducer may result.

Do not install the transducer where noise or air bubbles is present.

Performance will be affected.

ii

CAUTION

The transducer cable must he handled carefully, following the guidelines below.

•Keep fuels and oils away from the cable.

•Locate the cable where it will not be damaged.

•The cable sheath is made of chloro- phrene or polychloride vinyl, which are easily by damaged plastic solvents such as toulene. Locate the cable well away from plastic solvents.

Image 4

Contents Color LCD Sounder 00080922000 Safety Instructions Damage to the transducer may result Table of Contents System Configuration Standard supply Equipment ListsOptions Available transducers Vii Viii KW/2 kW transducer 28/45 Steel 28F-8 Steel 50B-6/6B Xii Xiii Xiv Display Unit MountingMounting considerations Mounting procedure Removing the display unit from the mounting baseFlush mounting Flush mounting display unitHow to mount transom mount water Temperature sensor T-02MTB Water Temperature Sensor optionTransducer Thru-hull mount water temperature sensor T-02MSB, T-03MSB Water temperature/speed sensor ST-02MSB, ST-02PSB Wiring Wiring diagram for standard-type FCV-1100LWiring Standard Equipment Power cableTransducer GroundWiring Optional Equipment Input/Output SentencesThis page is intentionally left blank Language Setting Initial SettingInitial display screen Transducer Data Maker Frequency Type RemarksInstallation main menu Entering transducer data by transducer model numberScroll bar Dialog box for 200 kHzDisplay unit, rear view Transducer settingTerminal board Entering transducer data by transducer specifications Menu for manual entry of transducer specificationsWater Temperature Sensor Setting Temp Setting menuSensor Nav Data, Heading Sensor Setting NAV Data Setting menuTrue MAG Installation menu Propagation VelocityDemonstration Mode Demo menuRestoring Default Settings This page is intentionally left blank Appendix Transducer 50BL-12/50BL-24H AP-1Appendix NEW BLT Transducers AP-2AP-3 Appendix 2 NEW BLT TransducersAP-4 Page Page Page Page Nov Page