
VSS™GATE
Gate Type
(Level, Decay, Both) Selects what the Gate shall work on: Level takes down the Output level like a normal gate. Decay rolls off the Decay time according to the Gate Decay setting, but leaves the Output level unattached. Both will do Output level roll off and Decay roll off at the same time.
Decay
(0.01 - 20s) The Decay time of the Reverb. Usually associated with the time it takes the Reverb tail to decay 60dB. This is the overall Master Decay for the four band Decay parameters. (found in the REVERB section below) who are multiples of this base Reverb time.
Early Lev
Rev Lev
Mix
(0% - 100%) Wet/Dry mix. Can be frozen at 100% on the I/O menu.
Out Level
Rev Delay
(0 - 200ms) A delay to the tail of the Reverb. Adds additional time between the Early Reflections and the onset of the “tail” of the reverb.
Pre Delay
Hi Color (available in easy mode only)
Adjusts the spectral balance in the high end frequencies This is actually a simple way of adjusting a complex selec- tion of frequencies.
Lo Color (available in easy mode only)
Adjusts the spectral balance in the
A simple way of adjusting a complex selection of frequen- cies.
Expert mode
Press OK to gain access to the following additional parameters.
Note: Hi Color and Lo Color is not available in this mode.
Early Reflections
Early Type
(Several types) Pick the type that best compliments your material or best represents the effect you are going for.
Early Bal
Color
(±50) Adjust the spectral balance of the Early Type.
Low Cut
(20Hz - 400Hz) This adjustable filter removes low frequencies for the Early Reflections.
36