VSS™FP - FILM & POST
Lo Damp Freq
(20Hz - 200Hz) Sets the Lo Cut frequency for the next parameter, Lo Damp. Use these two parameters to take away any objectionable low frequencies entering the Reverb tail processor.
Lo Damp
Modulation
The Reverb Mod and the Space Mod work on the tail of the reverb and give you the ability to tweak the tail in different ways.
To isolate and listen only to the tail you should turn the Early level off; set the mix to 100% and then turn the Depth parameter all the way up.
Try changing the Type of Modulation and listen to its effect on the tail. Be aware that by using extensive modulation of the tail you might get a detuning effect of the source material. In that case reduce the Width and Depth.
Reverb Mod
Type
(Off, Smooth 1, Smooth 2, Perc, Wow, Vintage, Wild) Adjusts the type of modulation.
Rate
Width
(0% - 200%) Sets the Width of the modulation.
Space Mod
This group of parameters sets the way the sound moves about the room.
Type
(Off, Normal, Fast, Slow, MidFreq, Sync).
Rate
Width
(0% - 100%) Sets the width of the modulation.
Depth
41