Samson Graphite 25 owner manual Rear Panel Controls and Functions

Page 11

Graphite 25 · USB/MIDI Keyboard Controller

Rear Panel Controls and Functions

1.POWER Switch - Use this switch to turn the keyboard on or off.

2.DC IN - The Graphite 25 can be powered using a 9V 300mA adaptor, connected to the DC IN jack.

3.USB Connection - Connect a standard USB cable from this port to the USB connection on a computer or iPad to provide power to the keyboard, as well as to send and receive MIDI data.

4.MIDI OUT - Use a 5-pin MIDI cable to connect the Graphite 25 to an external MIDI device.

5.SUSTAIN Pedal Input - Connect a ¼” sustain pedal to this input. This input is preset from the factory to send MIDI sustain (CC #64) messages. The SUSTAIN pedal input can be assigned to send different MIDI parameters in Setup Mode.

11

Image 11

Contents USB Midi Controller Copyright 2013 Samson Technologies Important Safety Information Page Important Safety Information Contents Introduction Minimum System Requirements Graphite 25 FeaturesSystem Components Front Panel Controls and Functions Front Panel Controls and Functions Rear Panel Controls and Functions Quick Start Button Indicators Display FeaturesPreset Status IndicatorsGraphite 25 Modes Computer Remote Control PresetsUser Presets Preset ModeGraphite Preset Remote Control PresetsParameter Controller Data Remark Setup ModeControllers Hard Editing the Aftertouch ControlSelecting the Keyboard Velocity Curve Available Velocity CurvesSelecting Velocity Curve for the Trigger Pads Switch the Local ControlPedal Setup Preset ResetEditing Zones Zones ModeSection of the keyboard Zn Port Transmitting port Zn Ch Performance Mode Trigger Pads Performance Mode ParametersPerformance Controls Transport Buttons Midi OUT Operational Flow Chart Description Type Midi Continuous Controller CC ListNrpn LSB Play MMC Controller Type Message Mode Factory Default SettingsZones Other Factory SettingsOctave Midi Note NumbersControls Specifications