Samson Graphite 25 owner manual Setup Mode, Controllers, Parameter Controller Data Remark

Page 17

Graphite 25 · USB/MIDI Keyboard Controller

Setup Mode

Setup Mode enables you to make adjustments to how the Graphite 25 will operate. Pressing the SETUP button will enter Setup Mode, the keyboard will stop transmitting MIDI data, and the first 18 keys will serve as numerical input and access to additional functions.

Controllers

To adjust a controller, press a button, move a slider or encoder, or press the pedal, and its name and parameter values will appear on the display.

Press the PAGE ◀ / ▶ buttons to cycle through the available parameters (see table below). The parameter name will be displayed and the value will flash. Use the DATA +/– buttons or numerical keys to set the appropriate value.

Note: When the value Ch is set to “-“, the controller follows the keyboard channel in Zone 1. You can use the DATA button to select “-“, or press the 0 key on the keyboard to select “-“.

+/-

+/-

Press the ENTER button or the ENTER key on the keyboard to confirm a selection. You can confirm the selection after each parameter, or after you finish editing all parameters for a controller. The new values will be saved and updated on the display.

Note: The encoder settings are saved into the current activated bank. Press the BANK ◀ / ▶to change the bank where the settings will be saved.

If you select another controller, or press the SETUP or MAIN buttons before saving your changes, your changes will be lost. Simultaneously pressing the DATA + and DATA – buttons will restore the controller to its original setting.

The setting of the slider, encoders and transport buttons cannot be changed in the Remote Control Preset. The components assigned to the function buttons vary according to the software title you are using.

Parameter

Controller

Data

Remark

 

 

 

 

Type

Button or Pad

0: Control

 

 

 

1: Note

 

 

 

 

 

Mode

Button or Pad

0: Toggle

 

 

 

1: Momentary

 

 

 

 

 

Ctrl or Note

Button or Pad

Control: 0–171 (ex-

Depending on Type selection

 

 

cept 152 and 153)

 

 

 

Note: 0–127

 

 

 

 

 

Ctrl

Encoder or Slider

0–171

Refer to MIDI Continuous Controller

 

 

 

List in the back of the manual

 

 

 

 

Port

All

1–5

Transmitting Port

 

 

 

 

Ch [1]

All

1–16

Transmitting Channel

 

 

 

 

[1]To set the controllers to follow the keyboard channel in Zone 1, press the 0 key, or use the DATA buttons to select “--” on the display.

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents USB Midi Controller Copyright 2013 Samson Technologies Important Safety Information Page Important Safety Information Contents Introduction Minimum System Requirements Graphite 25 FeaturesSystem Components Front Panel Controls and Functions Front Panel Controls and Functions Rear Panel Controls and Functions Quick Start Preset Display FeaturesStatus Indicators Button IndicatorsGraphite 25 Modes Computer Remote Control PresetsGraphite Preset Preset ModeRemote Control Presets User PresetsParameter Controller Data Remark Setup ModeControllers Selecting the Keyboard Velocity Curve Editing the Aftertouch ControlAvailable Velocity Curves HardPedal Setup Switch the Local ControlPreset Reset Selecting Velocity Curve for the Trigger PadsEditing Zones Zones ModeSection of the keyboard Zn Port Transmitting port Zn Ch Performance Mode Trigger Pads Performance Mode ParametersPerformance Controls Transport Buttons Midi OUT Operational Flow Chart Description Type Midi Continuous Controller CC ListNrpn LSB Play MMC Controller Type Message Mode Factory Default SettingsZones Other Factory SettingsOctave Midi Note NumbersControls Specifications
Top Page Image Contents