Graphite 25 · USB/MIDI Keyboard Controller
Setup Mode
Selecting Velocity Curve for the Trigger Pads
Press the Pad Vel key to select a velocity curve for the trigger pads. “P.Curve” will appear in the Op- eration area of the display with its current velocity curve number in the data area . The Operation area will then change to show the current velocity curve. Use the DATA +/– buttons or enter the number by pressing the numerical keys on the keyboard. Press the ENTER key or the ENTER but- ton to confirm your setting and save it. The name of the velocity curve will be updated. The value display will stop blinking. Selectable curves are the same as keyboard velocity curves.
Switch the Local Control
The USB out from port 1 or 2 can be transmitted through the MIDI Out jack. This is controlled by the local setting. Press the Local key to switch the local control On/Off. “Local” and its current status will appear in the Operation area of the display, and flash. Press the DATA + (or numerical key 1) to turn Local Control on and DATA – (or numerical key 0) to turn Local Control off. Press the ENTER key or the ENTER button to confirm your setting and save it. When local is on, “Local” will appear in the Status Indicator area on the right side of the screen.
Pedal Setup
Press the pedal to assign a control code for the pedal. “Pedal” will appear in the Operation area of the display with the value of the current control in the data area. The value is also shown and will blink under the Val tag on the second row of the display. Use the DATA +/– buttons to change the value or enter the data by pressing the numerical keys on the keyboard. Press the ENTER key or the ENTER button to confirm your setting and save it. The value display will stop blinking.
Preset Reset
Press the Preset key to reset to the factory default setting. “Reset No” will appear in the Operation area of the display and “No” will blink. Press DATA + (or numerical key 1) to switch it to “Yes” or DATA – (or numerical key 0) to switch it “No.” Press the ENTER key or the ENTER button to confirm your decision. When the Yes is confirmed, the Reset sign will appear in the Status Indicator area on the right side of the screen and “Loading…” will appear in the Operation area of the display. After the reset is finished, the display will show “Reset OK”.
Mute Control
Messages for the operations of the encoders and slider are normally transmitted immediately with movement of the controller. You can set the Graphite so that it transmits all encoder and slider movements simultaneously. This is controlled by the MUTE setting. Press the Mute key to switch the mute control On/Off. “Mute” and its current status will appear in the Operation area of the display and flash. Press DATA + (or numerical key 1) to turn Mute Control on and DATA – (or numerical key 0) to turn Mute Control off. Press the ENTER key or the ENTER button to confirm your setting. When mute is on, “Mute” will appear in the Status Indicator area on the right side of the screen.
19