Kawai CN33 manual Product should be connected to

Page 5

Page

5

WARNING - When using electric products, basic precautions should always be followed, including the following.

WARNING

 )   &.&    & 

  '&) &     

The product should be connected to

#

#

#

 %  %  ) , 

an AC outlet of the specified voltage.

 

 

 



(&&& ) %&)

 

 

 

 



    &)) ,+ %

 

 

 

 

       

Do not insert or disconnect the power

 

 

 

  %   & (

cord plug with wet hands.

 

 

 

 

 

Take care not to allow any foreign

 

 

 

  ,   &)   

matter to enter the product.

 

 

 

 $( ,  & 

 

 

 

 

"&) &  $-)  )) % 

 

 

 

 

) & %  $' ,& *&

 

 

 

 

+& $)  &) 

The chair must be used properly (it must be used only when playing the product).

Do not play with it or stand on it.

Only one person is allowed to sit on it. Do not sit on it when opening the lid. Re-tighten the bolts occasionally.

When using the headphones, do not listen for long periods of

time at high volume levels.

Do not lean against the keyboard.

Do not disassemble, repair or modify the product.

When disconnecting the AC power cord's plug, always hold the plug

and pull it to remove it.

The product is not completely disconnected from the power supply even when the power switch is turned off. If the product will not be used for a long time, unplug the AC power cord from the AC outlet.

  %  &&   +    % $))  %  '

  "    # "& !  

  "  #&    '   "  $

        !      

  "#& (    "  #  " # %   # 

                        

This product may be equipped with a polarized line plug (one blade wider than the other). This is a safety feature.

If you are unable to insert the plug into the outlet, contact an electrician to replace your obsolete outlet.

Do not defeat the safety purpose of the plug.

It is a good practice to have the instrument near the AC outlet and the power cord plug in a position so that it can readily be disconnected in an emergency because electricity is always charging while the plug is in the AC outlet even in a power switch off condition.

Image 5
Contents Appendices Page Table of Contents Important Safety Instructions Product should be connected to Doing so may cause the product to generate noise Is handled incorrectlyProduct and other devices Declaration of Conformity ‘ Pedals ‘ Front Panel‘ Headphones and USB Connectors ‘ Setting UP the Piano Adjust the volume level using the Master Volume sliderBasic Operations Play the pianoPress the Concert Magic and Lesson buttons simultaneously Demo SongsPress the Electric Piano button Selecting a SoundSelect other sounds Turn onButtons will turn on Dual ModePrimary sound has changed to Studio Grand Increases the volume Press the Split button Split ModePress the PIANO2 button three times Press the Split button to deactivate split modeLED indicator for the Split button will turn off Four Hands Mode Press the Split button again to deactivate Four Hands mode ‘ Adding Reverb Reverb and Effects‘ Applying Effects Press the Effects button again to deactivate the effectsTranspose Press the Tempo button MetronomePress the Tempo button again to deactivate the metronome Press the Beat buttonVolume level of the metronome can also be adjusted Step ‘ Adjusting the Metronome VolumePress the Beat button again to deactivate the metronome Press the Tempo and Beat buttons simultaneouslyCN33 control panel will return to normal operation Panel LockPress the Concert Magic and USB buttons simultaneously ‘ Selecting a Song Press the PLAY/STOP button‘ Listening to the Song Song number will be briefly shown in the display‘ Performing a Song Use the Balance slider to adjust the volume balance‘ Concert Magic Part Volume Balance „ Easy Beat ‘ Concert Magic Song Arrangement TypesStart by tapping any key with a constant steady beat Press and hold the Concert Magic button‘ Steady Beat ‘ Concert Magic Demo ModesCurrent tempo will be shown in the LED display Step ‘ Concert Magic Playback SpeedPress the Lesson button Selecting a BOOK/SONGListening to and Playing a Song ‘ Adjusting the Tempo of a SongPress the PLAY/STOP button to play the selected song ‘ Exiting the Lesson FunctionPress the REC button Recording a Song PracticePress the PLAY/STOP button to listen to the recording ‘ Playing Back the RecordingIf no Part is selected PART1 will be selected automatically Recording REC Button‘ Recording a Second Part Start to play the pianoPress the PLAY/STOP button to stop recording Press the PLAY/STOP button to finish recording ‘ Playing Back Recorded Parts Separately Playing Back a SongPress and hold the REC and PLAY/STOP buttons LED indicator of the selected song will start to flash StepErasing a Song Selected song will start to play After connecting a USB device, press the USB buttonUSB Play USB Load Overwriting the file USB SaveSelected song will be deleted Step USB DeleteConfirmation message will be shown in the display USB Format Press any of the panel buttons shown below ‘ Entering a Function Mode‘ Exiting a Function Mode Lower Octave Shift can be set from 0 to Lower Octave ShiftLower Pedal ON/OFF Damper Hold ON/OFF Damper Effect Press the S or Tvalue buttons to select the desired setting D  B String ResonanceTouch Curve Four Hands ON/OFF Press the S or Tvalue buttons to raise or lower the pitch TuningBrief Explanation of Temperaments Temperament‘ KEY Signature of Temperament ‘ Midi Overview Channel number can be set from 1 to Midi ChannelPress the S or Tvalue buttons to change the channel number Transmit Program Change ON/OFF Transmit Program Change Local Control ON/OFF MULTI-TIMBRAL Mode ON/OFF Channel Mute Send Program Change Numbers Press the REC button to execute the save operation User MemoryFactory Reset Appendices ‘ Connecting to Other Devices‘ USB Midi Screw I4 x 30 x ‘ Assembly InstructionsRemove the protective film from the display ‘ Specifications 10 F7 ‘ Midi Exclusive Data FormatFunction Transmit Receive Remarks ‘ Midi Implementation ChartPage KPSZ-0324 OW1036E-I1001 Version