Pioneer DJM-5000 operating instructions Connections, Rear Panel

Connections

Be sure to turn off the power and unplug the power cord from the power outlet whenever making or changing connections. Refer to the operating instructions for the component to be connected.

Connect the power cord after all the connections between devices have been completed.

Rear Panel

1 2 3 4 3 4 4 5 4 5 6 7

RL

RL

1716

1ZONE (page 7)

ZONE	LINE L CD CH-4
3 COLD 1 GND

2 HOT	-12dB -6dB0dB
	ZONEATT.		R
MASTER1		R	L	MASTER2
1 GND	-12dB -6dB0dB
3 COLD 2 HOT MASTERATT.

15 14

						DJM-5000
LINE L	CD CH-3		CD L	CH-2 CD L	CH-1	MIC 2
			CONTROL		CONTROL MIC 3
R			R	R		DIGITAL IN	USB
R	L	REC OUT	R BOOTH L	R SEND L(MONO)	R RETURN L(MONO)
			（TRS）			2 1
13			12	11	10	9	8

ARETURN (page 7)

An output terminal for the ZONE channel.

2ZONE ATT

Use to switch the attenuation level of audio signals output at the [ZONE] terminal. Select from 0 dB, -6 dB and -12 dB.

3LINE (page 7)

Connect to a cassette deck or a line level output component.

4CD (page 7)

Connect to a DJ player or a line level output component.

Connect to the output terminal of an external effector. When the [L] channel only is connected, the [L] channel input is simultaneously input to the [R] channel.

BSEND (page 7)

Connect to the input terminal of an external effector. When the [L] channel only is connected, a monaural audio signal is output.

CBOOTH (page 7)

Output terminals for a booth monitor, compatible with balanced or unbal- anced output for a TRS connector.

5CONTROL (page 7)

This is a control terminal for a DJ player. Use the fader of this unit to control a DJ player.

6MIC3 (page 7)

Connect to a microphone.

7MIC2 (page 7)

Connect to a microphone.

DREC OUT (page 7)

This is an output terminal for recording.

EMASTER2 (page 7)

Connect to a power amplifier, etc.

FMASTER ATT

Use to switch the attenuation level of audio signals output at the [MASTER1] or [MASTER2] terminal. Select from 0 dB, -6 dB and -12 dB.

8	USB (page 8)	G MASTER1 (page 7)
	Connect to a computer.	Connect to a power amplifier, etc.
9	DIGITAL IN (page 7)	H AC IN
	Connect to a digital audio output component.	Connect the supplied AC power cable to the AC IN inlet, then plug into a

power outlet. Plug in the power cable after all connections have been made.

6En