Additional information, Troubleshooting | Pioneer DJM-5000 instruction

Additional information

Troubleshooting

!Incorrect operation is often mistaken for trouble or malfunction. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Inspect the other components and electrical appliances being used. If the trouble cannot be rectified after checking the items below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.

!The player may not operate properly due to static electricity or other external influences. In such cases, normal operation may be restored by unplugging the power cord then plugging it back in.

Problem	Check	Remedy
The power is not turned on.	Is the power cord properly connected?	Plug in the power cord to an AC outlet.

No sound or small sound.	Is the position of the input selector switch properly set?	Switch the input source of a channel with the input selector switch (page
		12).

	Are the connection cables properly connected?	Connect the connection cables properly (page 7).
	Are the terminals and plugs dirty?	Clean the terminals and plugs before making connections.
	Is [MASTER ATT] on the rear panel set to a level like -12 dB?	Switch [MASTER ATT] (page 6).

Distorted sound.	Is the level of audio output from the microphone channel	Adjust the [LEVEL] dial for [MASTER] so that the master channel level
	properly set?	indicator lights at about 0 dB at the peak level (page 12).

		Set [MASTER ATT] to [-6 dB] or [-12 dB] (page 6).
	Is the level of audio input to each channel properly set?	Adjust the [TRIM] control such that the channel level indicator lights up
		near 0 dB at the peak level (page 12).
Can’t crossfade.	Is the crossfader assign switch properly set?	Set the crossfader assign switch properly for each channel (page 12).

Can’t fader start a DJ player.	Is [FADER START] set to off?	Set [FADER START] to on (page 13).

	Is the DJ player properly connected to the [CONTROL]	Connect a DJ player to the [CONTROL] terminal with a control cord (page 7).
	terminal?

Are the audio cables properly connected?

Connect this unit to the audio output terminal of a DJ player with an audio cable (page 7).

No effect.	Is [EFFECT] set to a proper position?	Set [EFFECT] to a position other than [LOW] (page 12).
Can’t use an external effector.	Is [SEND/RETURN] [ON/OFF] set to on?	Press [ON/OFF] of [SEND/RETURN] to turn on [SEND/RETURN] (page 12).

	Is the external effector properly connected to the [SEND]	Connect an external effector to the [SEND] or [RETURN] terminal. When the
	or [RETURN] terminal?	connection is made properly, [ON/OFF] of [SEND/RETURN] lights up in red
		(page 7).
	Is the output channel switch of [SEND/RETURN] properly	Switch the output channel with the output channel selector switch(page 12).
	set?
Distorted sound from an external effector.	Is the level of audio input from the external effector prop-	Turn the [LEVEL] dial for [SEND/RETURN] to adjust the audio level output
	erly set?	from the external effector (page 12).
This unit is not recognized after it has been connected	Is the driver software properly installed on your computer?	Install the driver software. Reinstall it if the driver software has already been
to a computer.		installed (page 8).
		Unless this unit is properly connected to the computer and there is no error
		in data transmission, the version display utility program cannot display the
		firmware of this unit. For details of how to check, see Checking the version of
		the driver software on page 10.

About the exemption clauses

!Pioneer is a registered trademark of Pioneer Corporation.

!Microsoft®, Windows Vista®, and Windows® are registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries.

!Pentium is a registered trademark of Intel Corporation.

!Adobe and Reader are either registered trademarks or trademarks of Adobe Systems Incorporated in the United States and/or other countries.

!Apple, Macintosh or Mac OS are registered trademarks of Apple Inc. in the United States and/or other countries.

!ASIO is a trademark of Steinberg Media Technologies GmbH.

!The names of companies and products mentioned herein are the trademarks of their respective owners.

This product has been licensed for nonprofit use. This product has not been licensed for commercial purposes (for profit-making use), such as broadcast- ing (terrestrial, satellite, cable or other types of broadcasting), streaming on the Internet, Intranet (a corporate network) or other types of networks or dis- tributing of electronic information (online digital music distribution service). You need to acquire the corresponding licenses for such uses. For details, visit http://www.mp3licensing.com.

The audio compression technology for MP3 is offered under the license of

Fraunhofer IIS and Thomson Multimedia.

16En