QUICK OPERATION GUIDE (1/3)
USING BEAT EFFECTS [BPM MODE]
1.Select the BPM measurement mode.
Press the BPM MODE button so that the button lights together with the desired mode indicator (AUTO/MIDI/TAP).
2.Select effect type.
Press the DELAY, ECHO, PITCH ECHO, TRANS, FLANGER, FILTER or PHASER button and the pressed button starts to flash.
3.Select the sound range for the effect.
Press the button of the frequency (LOW, MID, HI) you wish to affect by the beat effect and the corresponding indicator lights.
4.Select the beat with which the effect is
to be synchronized.
Press a beat select button (1/8, 1/4, 1/2, 3/4, 1/1, 2/1, 4/1 or 8/1) to light the desired button.
5. Apply an effect.
Press the lever towards you (ON position) to start operation; release it and it returns to the center position (OFF position). In the center position (OFF position), the original sound is not affected. Press the lever away from you to lock it in position so that the beat effect is applied also when the lever is released.
TIME/BPM dial
Set the desired effect time as in step 4.
Turn the TIME/BPM dial while holding down the TAP/SHIFT button to make the desired BPM setting. When also the BPM MODE button is held down, BPM can be set in 0.1 increments.
TAP/SHIFT button
BPM can be manually adjusted by adjusting the beat (quarter notes) and hitting this key two times or more.
Adjusting the input level
Input signals to the input connectors, and adjust the INPUT LEVEL dial.
Adjusting effect output level
Rotate the EFFECT OUT LEV. dial to adjust the effect output level.
Changing the level meter display mode
Each time the METER MODE button is pressed, the level meter display alternates as follows:
÷INPUT, OUTPUT light: Input and output monaural display.
÷INPUT, L, R light: Input stereo display.
÷OUTPUT, L, R light: Output stereo display.
EFFECT TIME | DEPTH dial |
display | Sets the parameter 1 of each |
| effect. |
BPM |
|
measurement | RHYTHM TAP display |
mode |
|
indicators | BPM COUNTER |
MIX dial | CHARACTER dial |
Adjusts the balance between | Sets the parameter 2 of each |
the original sound and effects. | effect. |
4
<DRB1369>