Sony RS-232C manual Line OUTPUT3-8 Parameter Request, 52H 4FH 4DH 33H-38H ‘ROL3-8’

LINE OUTPUT3-8 PARAMETER REQUEST :

52[H] 4F[H] 4D[H] 33[H]-38[H] (‘ROL3-8’)

This command is used to read the setup of any desired single channel of the LINE OUTPUT 3 to 8 from the SRP-X700P. The commands that correspond to the respective channels are shown below.

CHANNEL	Command
LINE OUTPUT 3	43[H] 4F[H] 4C[H] 33[H] ‘ROL3’
LINE OUTPUT 4	43[H] 4F[H] 4C[H] 34[H] ‘ROL4’
LINE OUTPUT 5	43[H] 4F[H] 4C[H] 35[H] ‘ROL5’
LINE OUTPUT 6	43[H] 4F[H] 4C[H] 36[H] ‘ROL6’
LINE OUTPUT 7	43[H] 4F[H] 4C[H] 37[H] ‘ROL7’
LINE OUTPUT 8	43[H] 4F[H] 4C[H] 38[H] ‘ROL8’

•Packet format

52[H] 4F[H] 4C[H] 33[H] “parameter” 0D[H]

(In the case of LINE OUTPUT 3)

•Parameter

Specify the scene No. of the scene memory that you want to read, as the parameter.

Method of specifying the scene No. is the same as that of the GROUP FADER command. See page 29.

•Return packet format

When communication with the SRP-X700P is established with success, the parameter is returned together with ACK (41[H] (‘A’)) in the order shown below.

41[H] “parameter” 0D[H]

The parameter is the same as the 25 bytes of the LINE OUTPUT 3 through 8 commands’ parameter from which the scene No. is exempted.

MIC INPUT : 43[H] 49[H] 4D[H] 31[H]-36[H] (‘CIM1-6’)

This command is used to implement setting up the desired single channel of the MIC1/WL1 to MIC6/LINE2 input channels. Various setups can be memorized in the scene memories by specifying these scene Nos.

The commands that correspond to the respective channels are shown below.

CHANNEL	Command
MIC1/WL1	43[H] 49[H] 4D[H] 31[H] (‘CIM1’)
MIC2/WL2	43[H] 49[H] 4D[H] 32[H] (‘CIM2’)
MIC3	43[H] 49[H] 4D[H] 33[H] (‘CIM3’)
MIC4	43[H] 49[H] 4D[H] 34[H] (‘CIM4’)
MIC5/LINE1	43[H] 49[H] 4D[H] 35[H] (‘CIM5’)
MIC6/LINE2	43[H] 49[H] 4D[H] 36[H] (‘CIM6’)

– 41 –