Roland owner manual Using the VS-700R I/O in Standalone Mode, Changes to the Settings

Page 11

Using the VS-700R I/O in Standalone Mode

To use the VS-700R I/O without connecting it to the VS-700C console, it needs to be set to “Standalone mode.”

While in Standalone mode, AUX IN cannot be used.

Changes to the Settings

In order to use the VS-700R I/O in “Standalone mode,” you need to open the top cover (ARX slot), then set the SETTING dip switches to the positions shown below. Next, switch the unit's power off, then turn it back on again.

Normal setting

Settings for Standalone mode

11

Image 11

Contents Read this First Important Safety Instructions Never install the unit in any of the following locations Using the Unit Safely Using the Unit Safely Important Notes Important Notes Contents Checking the Contents of the Package USB Cable Changes to the Settings Using the VS-700R I/O in Standalone ModeAdvantages of Connecting VS-700R I/O Units Connecting Two VS-700R I/O UnitsConnect the Wordclock Example connections for monitoringConnecting the Power Cord If the USB indicator of the VS-700R I/O unit isn’t lit Turning the Power OnConnections to the Analog Jacks Connecting Recording EquipmentConnecting a Digital Audio Source Connections to the Digital ConnectorsSetting SONAR’s Sampling Rate p Switching the Sampling RateRestart Sonar Setting SONAR’s Sampling RateAudio Clock Source Setting Screen label ExplanationPort settings Midi input and audio output Installing the ARX Expansion BoardInstall the Expansion Board after removing the panel cover How to Install an Expansion BoardBoard Removing an Expansion Board French Language for Canadian Safety Standard Installation de la carte d’expansionCarte Installation d’une carte d’expansionCarte Retrait d’une carte d’expansion Attaching the Rackmount Brackets For EU Countries Compliance Information Statement Declaration of Conformity