Turning the Power On

Once the connections have been completed, turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices.

If you need to turn off the power completely, first turn off the POWER switch, then unplug the power cord from the power outlet. Refer to “Power Supply” (p. 6).

1.Minimize the VS-700C’s [AUDIO OUTPUT] knobs (three locations).

VS-700C Top Panel

2.Start up your computer.

3.Turn on the power switch of the VS-700C.

4.Turn on the power switch of two VS-700R.

5.Turn on the power switch of your monitor speakers.

VS-700C Rear Panel

Power On

VS-700R Front Panel

Power On

Due to a circuitry-protection feature, the VS-700R requires a few moments after power-up before it is ready for normal operation. If the connections are correct, the VS-700R’s USB indicator will light.

If the USB indicator of the VS-700R I/O unit isn’t lit

If the USB indicator of the VS-700R isn’t lit, the driver has not been installed correctly. Refer to the “Troubleshooting” chapter in “Getting Started.”

If the I/O indicator of the VS-700C console or the CONSOLE indicator of the VS-700R I/O unit is blinking

Check the following points.

•Are the VS-700C and VS-700R powered up?

•Are the VS-700C and VS-700R correctly connected via the dedicated cable?

•Is the VS-700 R I/O unit connected to your computer via a USB cable, and is the USB indicator of the VS-700R I/O unit lit?