Roland VS-700R Installing the ARX Expansion Board, Port settings Midi input and audio output

Page 21

Installing the ARX Expansion Board

Up to one optional Expansion Board (ARX series; sold separately) can be installed in the VS-700R.

For details on ARX expansion boards, refer to the owner’s manual of your ARX expansion board.

For details on the ARX expansion editor (plug-in), refer to the online manual for the editor (plug-in).

Port settings (MIDI input and audio output)

The ARX expansion board’s ports have the following names.

Port Name

MIDI Out Port

ARX

Audio In Port

ARX

Cautions When Installing an Expansion Board

•To avoid the risk of damage to internal components that can be caused by static electricity, please carefully observe the following whenever you handle the board.

•Before you touch the board, always first grasp a metal object (such as a water pipe), so you are sure that any static electricity you might have been carrying has been discharged.

•When handling the board, grasp it only by its edges. Avoid touching any of the electronic components or connectors.

•Save the bag in which the board was originally shipped, and put the board back into it whenever you need to store or transport it.

•Use a Phillips screwdriver that is suitable for the size of the screw (a number 2 screwdriver). If an unsuitable screwdriver is used, the head of the screw may be stripped.

•To remove a screw, rotate the screwdriver counter-clockwise. To tighten the screws, rotate the screwdriver clockwise.

•When installing Expansion Board, remove only the specified screws.

•Be careful that the screws you remove do not drop into the interior of the VS-700R.

• Do not leave the bottom cover removed. After installation of the Expansion Board is

loosen

tighten

 

 

complete, be sure to replace the cover.

 

 

•Be careful not to cut your hand on the opening for installing the board.

•Do not touch any of the printed circuit pathways or connection terminals.

•Never use excessive force when installing a circuit board. If it doesn’t fit properly on the first attempt, remove the board and try again.

•When circuit board installation is complete, double-check your work.

•Always turn the unit off and unplug the power cord before attempting installation of the circuit board (ARX series).

•Install only the specified circuit board (ARX series). Remove only the specified screws.

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Read this First Important Safety Instructions Never install the unit in any of the following locations Using the Unit Safely Using the Unit Safely Important Notes Important Notes Contents Checking the Contents of the Package USB Cable Changes to the Settings Using the VS-700R I/O in Standalone ModeAdvantages of Connecting VS-700R I/O Units Connecting Two VS-700R I/O UnitsConnect the Wordclock Example connections for monitoringConnecting the Power Cord If the USB indicator of the VS-700R I/O unit isn’t lit Turning the Power OnConnections to the Analog Jacks Connecting Recording EquipmentConnecting a Digital Audio Source Connections to the Digital ConnectorsSetting SONAR’s Sampling Rate p Switching the Sampling RateRestart Sonar Setting SONAR’s Sampling RateAudio Clock Source Setting Screen label ExplanationPort settings Midi input and audio output Installing the ARX Expansion BoardInstall the Expansion Board after removing the panel cover How to Install an Expansion BoardBoard Removing an Expansion Board French Language for Canadian Safety Standard Installation de la carte d’expansionCarte Installation d’une carte d’expansionCarte Retrait d’une carte d’expansion Attaching the Rackmount Brackets For EU Countries Compliance Information Statement Declaration of Conformity
Top Page Image Contents