Kramer Electronics Revision 6 manual Move the Stop Timer Action

Contents
Figure 81: Move the Stop Timer Action	42
Figure 82: Add the Start Timer Action	42
Figure 83: Button 1 Action List with Timer Triggers	42
Figure 84: The Add GPI/O Trigger Button	43
Figure 85: Selecting GPI/O via the Port Manager	43
Figure 86: Selecting Digital Input for a Temperature Sensor	43
Figure 87: GPI/O Threshold Window	44
Figure 88: GPI/O Trigger Properties Window for Digital Input	44
Figure 89: GPI/O Trigger Timeout (Digital Input)	45
Figure 90: Selecting the GPI/O Trigger from the Available Triggers List	45
Figure 91: Adding Actions to the GPI/O Trigger	45
Figure 92: The GPI/O Defined as Digital Output	46
Figure 93: The GPI/O Trigger Properties Window	46
Figure 94: Select the Behavior of the Digital Input Trigger	47
Figure 95: Selecting the Device from the Control Room List	47
Figure 96: Selecting a Button	47
Figure 97: The Button Trigger Properties Window	48
Figure 98: Select the Button Behavior	48
Figure 99: Button Trigger Properties Window (Activate while Pressed)	48
Figure 100: Button Trigger Properties Window (Toggle 1-2-3-4)	49
Figure 101: The Toggle Number in the Action List	49
Figure 102: Button Trigger Properties Window (States)	49
Figure 103: The State Num in the Action List	49
Figure 104: Knob-Turning Trigger	50
Figure 105: Port Commands	51
Figure 106: The Relay Actions (Port Switch)	51
Figure 107: Button Light Actions	51
Figure 108: Button Color Selection	52
Figure 109: Button Ignore States	52
Figure 110: Set LCD Label Text	52
Figure 111: Switcher Commands	53
Figure 112: Power Amplifier Commands	53
Figure 113: Panel Lock States	53
Figure 114: Unlock Message	54
Figure 115: Unlock PIN Code	54
Figure 116: Timer Start/Stop States	54
Figure 117: LEDs Light States	54
Figure 118: Select LEDs to Light	55
Figure 119: Definition of 4 States	55
Figure 120: The States Action Type	56
Figure 121: Setting the State Action List	56
Figure 122: Setting the State Action List	56
Figure 123: Using States in an Action List	57
Figure 124: The Delay Action Type	57
Figure 125: Loading a Configuration	58
Figure 126: New Configuration Warning Window	58
Figure 127: Configuration Mismatch Warning	59
Figure 128: The K-NET ID Connect Window	59
Figure 129: Setting K-NET ID	59
Figure 130: The Driver Manager Window	60
Figure 131: New Serial Command Window	61
Figure 132: Writing a Serial Command	62
Figure 133: Coloring the Serial Commands	62
Figure 134: Setting the Device as an Auxiliary Device	63
Figure 135: Connect to IR Capture Device Window	63
Figure 136: New IR Command Window	64
Figure 137: IR Command Area Window	64
Figure 138: IR Emitter Wiring	64
Figure 139: Defining a New Vendor, Device and Revision	65

iv

KRAMER: SIMPLE CREATIVE TECHNOLOGY