The Driver Manager
To create a new IR command for the RC device:
1.Click the New button in the IR commands area to type the new command name. The following window appears:
Figure 136: New IR Command Window
2.In the Command area, click the Connect to IR Capture Device button, select the port and click OK.
3.Click the Read IR button to read the command.
The command area displays the following message: “Ready for reading IR command. Please send IR command to the device”.
4.Press the appropriate button on the remote control transmitter.
The command area displays the following message: “IR command reading”. The IR command appears, as illustrated in Figure 137:
Figure 137: IR Command Area Window
You can test the IR command by connecting the RC unit IR terminal block connectors to the device via the IR emitter, and then clicking the
Figure 138 shows how to connect the IR emitter1. The white striped side connects to IR OUT, the black side connects to the Ground, and the LED Emitter Shell is affixed to the IR sensor window with the adhesive layer.
Figure 138: IR Emitter Wiring
Note: The dual IR emitter emits a weaker IR signal that may not be detected by some devices
1Using the Kramer 3.5mm to IR Emitter Control Cable
64 | KRAMER: SIMPLE CREATIVE TECHNOLOGY |