Buss Inputs & Outputs

High		0
High
12KHz
	-15	dB	+15
Mid		0
Mid
1KHz
	-15	dB	+15
Low		0
80Hz
	-15	dB	+15
Mon 4 5		6
1	3		7

1 9


Mon		0	5	10
Mon		4	5	6
2	3			7

0 10

EFX

010

Aux

mc12d

7. Mon 1 and Mon 2 Controls

The Mon 1 and Mon 2 controls are post-EQ and pre-fader; the audio signal is sent to the respective Mon Send masters and Monitor Out jacks.

8. EFX Control

The EFX control sends post-EQ, post-fader channel signal to the EFX Send Master and Internal Effects processor.

9. Aux Control

The Aux control sends post-EQ, post-fader signal to the Aux Send Master and Aux Send jack.

10. Bal Control

The Balance control affects the main-mix balance going to the L&R masters.

11. MUTE Switch

The Mute Switch disconnects the specified channel from all outputs. The channel can still be monitored through the Phones and on the VU-Meter when the Solo is activated in PFL mode.

12. CLIP LED

The Clip LED indicates the channel’s signal capacity has been exceeded; reduce the Gain setting if continuously illuminated.

13. ACT LED

The Act (Activity) LED pulses with the input signal to indicate channel Activity

14. SOLO Switch

Use the Solo switch to isolate the channel through the headphone (Phones) amplifier and on the VU-Meter.

15. Channel Fader

The channel fader sends channel output to the L&R Masters and to the Media outputs.

010

Bal

1. Sends

The ¼-inch EFX and Aux unbalanced mono outputs are controlled by their respective Send masters. Unbalanced cables can be used.

SENDS

RETURNS

OUT

EFXEFX

Inserts

AuxAux

Tip: SEND

Ring: RETURN

1/4-inch Phone Plug

1/4-inch T.R.S. Phone Plug

XLR Plug

2. RETURNS

The ¼-inch L&R pairs of inputs (bal/unbal) are con- trolled by their respective EFX and Aux Rtn channels.

3. L&R XLR Out Jacks

The L&R XLR Out jacks are main mix XLR outputs con- trolled by the L&R Main master faders. The use of balanced cables is strongly recommended.

Media OUT

Mono OUT

Phantom Power

Media IN

Active

	Monitor OUT
Mon	Mon
1	2

Headphones Lamp