Pioneer VSX-D909S manual Initial Set Up, On Screen Display

Initial Set Up

On Screen Display

There are a number of possible ways to hook up the receiver to your video components, like a DVD player, and hook up to your receiver to your TV, but some of them will not allow you to use the on-screen display of this unit. To avoid this, you simply need to keep the following rules:

1Always use the same type of video cords to hook up your video components to the receiver as you use to hook up the receiver to your TV. For example, if you use composite video cords to hook up your DVD player to the receiver, use composite video cords to hook up the receiver to your TV. If you use S video cords to hook up your DVD player and the receiver, use S video cords to hook up the receiver to your TV.

2Always make sure your TV is set to the appropriate input channel (for example, video 1). Your TV may have a number of input channels and if you do not select the proper one, you will not be able to use this receiver’s on-screen display, or, in fact see any picture from this receiver at all. If you are unsure how to choose an input channel for your TV, refer to the manual which came with your TV.

You might, for example, use both composite and S video cords to hook up your video components with this receiver and then use composite video cords to hook up this receiver to your TV. This arrangement would still NOT let you see the on-screen displays from this receiver on your TV. The best idea is just to use one type of video cords for all your video component and TV hook ups.

Switching video system between PAL and NTSC (if necessary)

This receiver is able to use two types of video systems for its OSD (on screen display) either PAL or NTSC. If you don't match the system on the amplifier with your home system no OSD will appear on your TV. The default setting is NTSC, which is the standard in North America. If you use this system you don't need to make any settings here. People with multi-system TVs don’t need to worry about changing the setting either. If necessary, follow the instructions below to switch the type of video system.

STANDBY/ON					1 Put the receiver in the STANDBY mode.
					2 While holding down the LOUDNESS button
AUDIO/VIDEO MULTI-CHANNEL RECEIVER VSX-D909SDigital Signal P					press the STANDBY/ON button.
STANDBY/ON
	DSP	STEREO/			The video system type will change depending on the state the
STANDBY	MODE	DIRECT
		/DTS			receiver was previously in. The new type, either PAL or NTSC,
SIGNAL SELECT ADVANCED STANDARD
					will appear in the display. It will be shown for about seven
					seconds and then the receiver returns to normal operating
		MULTI CH	CHANNEL	DIGITAL	mode.
	VIDEO INPUT	INPUT	TONE SELECT	LOUDNESS NR
PHONES S-VIDEO	VIDEO L	AUDIO R
		SPEAKERS	- BASS +	- TREBLE +	To change the video system type again repeat steps 1 and 2.
					Make sure you press the LOUDNESS button, using others
					buttons may change this receiver’s settings.
		LOUDNESS
					When a PAL system is selected

When a NTSC system is selected

memo When using the PAL setting the OSD does not get displayed in color.

28