Pioneer VSX-D909S manual Digital Input Assignment, You should see the following display on your TV

Quick Start Guide

4Digital Input Assignment

This is only necessary if you did not hook up your DVD to DIGITAL IN 1, as in the first diagram on p. IV

2

ë￿	USE	SETUP
S0URCE		RECEIVER

	MULTI	SYSTEM
	OPERATION	OFF
DVD/LD	TV/SAT	VCR1	VCR2
	MULTI CONTROL
CD	MD/	TUNER	TVCONT
	TAPE1
CLASS	MPX	BAND	DIRECT ACCESS
¦￿	7	3	8
- TUNING +		- STATION +
1 Á￿		4 ¢
DTV ON/OFF	DTV MENU	- CHANNEL +
1	2		3
4	5		6
7	8		9
GUIDE	0		EXIT
			ENTER
+10			DISC
+	TV		+
TV VOL	TV CONTROL		VOLUME
–	TV FUNC		–
REMOTE SETUP
INPUT	MENU		MUTE
ATT

SYSTEM SETUP
EFFECT/	+	FUNCTION
CH SEL

ENTER

DIGITAL	–		SIGNAL
NR			SELECT
MIDNIGHT	MULTI CH	DSP	STEREO/
	INPUT		DIRECT
			/DTS
LIGHT		ADVANCED	STANDARD

AV PRE-PROGRAMMED AND LEARNING

REMOTE CONTROL UNIT

1Set the remote control slide switch to SETUP.

1Also make sure your TV is on and set to the receiver.

•When you're done setting up the receiver, remember to set the slide switch back to USE.

2Press the SYSTEM SETUP button.

You should see the following display on your TV.

System Setup

[Digital-In Select] [Speaker Setting] [Channel Delay] [Channel Level] [Crossover Network] [Bass Peak Level] [D-Range Control] [Multi Channel In] [Multi-Room]

•You can escape from this screen at any time by pressing the SYSTEM SETUP button again. None of the settings you

3-5 made will be entered in this case.

•If don't enter any settings the receiver will revert back to its previous state after three minutes.

3 Digital in Select should be selected (if it isn't use the 5´° buttons to select it). Press ENTER.

You should see the following display on your TV.

Digital-In Select
Digital-1	[			]
		DVD/LD
Digital-2	[	CD	]
Digital-3	[	MD	]
Digital-4	[TV/SAT ]
Digital-5	[ VCR1		]

[EXIT] L

4 Choose the Digital-3 you hooked up your DVD player to and assign "DVD/LD" to it.

Use the 2 or 3 buttons to choose the DVD/LD setting.

Digital-In Select
Digital-1	[DVD/LD]
Digital-2	[ CD		]
Digital-3	[	DVD/LD		]
Digital-4	[TV/SAT ]
Digital-5	[ VCR1		]

[EXIT] L

5Select EXIT with 5´° buttons and press ENTER to return to the SYSTEM SETUP MENU.

Digital-In Select
Digital-1	[	OFF	]
Digital-2	[	CD	]
Digital-3	[DVD/LD]
Digital-4	[TV/SAT ]
Digital-5	[ VCR1		]

[EXIT] L

VI