Pioneer VSX-D909S Learning Commands from Other Remote Controls, Press the Remote Setup button

Remote Control of Other Components

Learning Commands from Other Remote Controls

If preset codes are not available for your component(s), or the available preset codes do not operate correctly, you can use this function to program in signals from the remote control(s) of your other component(s). This operation can also be used after recalling a preset code to program additional operations not covered in the preset codes.

3

2,3

ë￿	USE	SETUP
S0URCE		RECEIVER

	MULTI	SYSTEM
	OPERATION	OFF
DVD/LD	TV/SAT	VCR1	VCR2
	MULTI CONTROL
CD	MD/	TUNER	TVCONT
	TAPE1
CLASS	MPX	BAND	DIRECT ACCESS
¦￿	7	3	8
- TUNING +		- STATION +
1 Á￿		4 ¢
DTV ON/OFF	DTV MENU	- CHANNEL +

1 2 3

4 5 6

7	8	9
GUIDE	0	EXIT
		ENTER
+10		DISC

+	TV	+
TV VOL	TV CONTROL	VOLUME
–	TV FUNC	–

REMOTE SETUP
INPUT	MENU	MUTE
ATT

SYSTEM SETUP
EFFECT/	+		FUNCTION
CH SEL
	ENTER
DIGITAL	–		SIGNAL
NR			SELECT
MIDNIGHT	MULTI CH	DSP	STEREO/
	INPUT		DIRECT
			/DTS
LIGHT		ADVANCED	STANDARD

AV PRE-PROGRAMMED AND LEARNING

REMOTE CONTROL UNIT

1

4

1 Set the remote control slide switch to

SETUP.

Also make sure that your TV is on and set to the receiver.

2 Press the REMOTE SETUP button.

The REMOTE SET UP menu appears on your TV screen.

Select Remote

Setup Mode

Remote SETUP+1

Preset Recall

Remote SETUP+2

Learning

Remote SETUP+3

Multi-Operation

Remote SETUP+4

Direct Function

3Press the REMOTE SETUP button and 2 at the same time to select the Learning setup

mode.

All the MULTI CONTROL buttons (except the TUNER button) start to blink.

To cancel Learning setup mode, press the REMOTE SET UP button.

Learning Setup

1Place both commanders pointing at each other.

2Select the item from the Multi-control buttons that should be duplicated. (ex. DVD) Multi-control button starts blinking.

EXIT = Remote Setup

4 Press the MULTI CONTROL button for the component you want to control.

Each button can be set to control one of the following components.

The selected button continues to blink.

Learning Setup

3Press one button that should be duplicated.

4Multi-Contorol button lights up.

5Press one button on the original commander, and hold 2 to 10 seconds.

6Repeat this process to duplicate next command. EXIT = Remote Setup

60