Pioneer VSX-D909S When you have adjusted each speaker level, Press Enter button to return to

Initial Set Up

ë￿		USE	SETUP
S0URCE			RECEIVER
	MULTI	SYSTEM
	OPERATION	OFF
DVD/LD	TV/SAT	VCR1	VCR2
	MULTI CONTROL
CD	MD/	TUNER	TVCONT
	TAPE1
CLASS	MPX	BAND	DIRECT ACCESS
¦￿	7	3	8
- TUNING +		- STATION +
1 Á￿ 4 ¢
DTV ON/OFF	DTV MENU	- CHANNEL +
1	2		3
4	5		6
7	8		9
GUIDE	0		EXIT
			ENTER
+10			DISC

4Adjust speaker levels so that you hear the test tone at the same volume from each speaker when seated in your main listening

position.

Note: The volume of the subwoofer tends to sound lower than it actually is, you may need to raise its level after testing the sound with actual soundtracks.

In AUTO mode

1Press the 2 or 3 button to adjust the level of the speaker outputting the TEST TONE.

In MANUAL mode

1Press the 2 or 3 button to adjust the level of the first speaker.

2Press the 5/° button to switch the TEST TONE to the next speaker.

3Repeat 1 and 2 for each speaker.

+	TV		+		If you are using a Sound Pressure Level (SPL) meter
TV VOL	TV FUNC		VOLUME		Take the readings from your main listening position and adjust
	TV CONTROL
–			–		the level of each speaker to 75 dB SPL (C-weighted/slow
INPUT	MENU		MUTE		mode).
REMOTE SETUP
ATT
SYSTEM SETUP
EFFECT/	+		FUNCTION
CH SEL				4-6 5	When you have adjusted each speaker level,
	ENTER
DIGITAL	–		SIGNAL		press ENTER button to return to the
NR			SELECT
MIDNIGHT	MULTI CH	DSP	STEREO/		previous screen.
LIGHT	INPUT		DIRECT
	ADVANCED		STANDARD
			/DTS
					The MASTER VOLUME will return to its original position.
AV PREREMOTE- CONTROL UNIT				6	Select EXIT with the 5/° buttons and press
PROGRAMMED AND LEARNING

ENTER button to return to the SYSTEM

SETUP MENU.

memo

Note that it is also possible to set channel levels temporarily. Then follow the same procedure as explained on this page. This function is designed to be used when you want to change the levels temporarily to raise the level of one channel. Using this method you can set speaker levels in different modes, such as, STEREO, and each DSP mode, independently. You should return the settings to their original state when done. Doing the set up procedures on this page will erase any temporary/independent level settings that have been made.

Next, proceed to CROSSOVER NETWORK on the next page.

If you want to change a setting before proceeding simply use the arrow buttons to go back.

36