Basic Playback
Playing Stereo Sources
The following instructions show you how to use the receiver for stereo audio or
memo If the TAPE 2 indicator is visible in the display, it means the TAPE 2 MONITOR is on. Press TAPE 2 MONITOR on the front panel to turn it off unless you want to listen to TAPE 2.
ë | USE | SETUP |
S0URCE |
| RECEIVER |
| MULTI | SYSTEM |
|
| OPERATION | OFF |
|
DVD/LD | TV/SAT | VCR1 | VCR2 |
| MULTI CONTROL |
| |
CD | MD/ | TUNER | TVCONT |
TAPE1 | |||
CLASS | MPX | BAND | DIRECT ACCESS |
2
3
4
1Turn on the power of the playback component.
2Put the remote control slide switch in USE.
¦ | 7 | 3 8 |
- TUNING + | - STATION + | |
1 Á 4 ¢ | ||
DTV ON/OFF | DTV MENU | - CHANNEL + |
1 | 2 | 3 |
4 | 5 | 6 |
7 | 8 | 9 |
GUIDE | 0 | EXIT |
| ENTER | |
+10 |
| DISC |
+ TV+
TV VOL | TV CONTROL |
| VOLUME |
– | TV FUNC |
| – |
REMOTE SETUP |
|
|
|
INPUT | MENU |
| MUTE |
ATT |
| ||
SYSTEM SETUP |
|
|
|
EFFECT/ | + |
| FUNCTION |
CH SEL |
|
| |
| ENTER |
|
|
DIGITAL | – |
| SIGNAL |
NR |
| SELECT | |
MIDNIGHT | MULTI CH | DSP | STEREO/ |
| INPUT |
| DIRECT |
|
|
| /DTS |
LIGHT | ADVANCED | STANDARD |
8
4
6
5
3 Press the RECEIVER button to turn on the receiver.
Be sure that the standby indicator turns off on the front panel.
4Press the MULTI CONTROL buttons or the FUNCTION button to select the source you
want to playback.
The FUNCTION button cycles through the sources in the following order:
DVD/LD TV/SAT CD MD TUNER
VCR 2 VCR 1 VIDEO PHONO
5Press the STEREO/DIRECT button to select the stereo mode.
AV
REMOTE CONTROL UNIT
The STEREO indicator lights on the display.
6Press the SIGNAL SELECT button to select the input signal corresponding to the
|
|
| source component. |
|
|
| (See “Switching Analog and Digital Signal Input” on page 47.) |
3 | 5 | 4 |
|
7 Start playback of the component you | |||
|
|
| selected in step 1. |
|
|
|
|
| 8 Adjust the volume by using the VOLUME | ||
|
| buttons on the remote control or the | |
DOWN | UP | MASTER VOLUME on the front panel. | |
| 8 | memo | You need to make sure the input is set to the appropriate |
|
| ANALOG or DIGITAL setting. Refer to page 47 for more | |
|
|
| |
|
|
| on this. |
46