Pioneer VSX-D909S manual Channel

Initial Set Up

Multi Channel In Setting

If you have a Multi Channel external decoder you can choose whether to have the sound level set to BYPASS, in which case only the main volume can be controlled, or to ADJUST, which means the levels can be reduced in volume. If continuing from Dynamic Range Control go to step 1. If starting fresh, complete steps 1-3 in “Setting Up for Surround Sound“ (p.29) first.

ë￿		USE	SETUP
S0URCE			RECEIVER
	MULTI	SYSTEM
	OPERATION	OFF
DVD/LD	TV/SAT	VCR1	VCR2
	MULTI CONTROL
CD	MD/	TUNER	TVCONT
	TAPE1
CLASS	MPX	BAND	DIRECT ACCESS
¦￿	7	3	8
- TUNING +		- STATION +
1 Á￿ 4 ¢
DTV ON/OFF	DTV MENU	- CHANNEL +
1	2		3
4	5		6
7	8		9
GUIDE	0		EXIT
			ENTER
+10			DISC
+	TV		+
TV VOL	TV CONTROL		VOLUME
–	TV FUNC		–

REMOTE SETUP

1 Use the 5´° buttons to select MULTI

CHANNEL IN.

See “Setting Up for Surround Sound“ on page 29 if you need more information.

Press the ENTER button.

This information will be displayed on your TV.

Multi channel in Select mode [Channel Level]

[BYPASS]

[EXIT]

INPUT	MENU	MUTE
ATT
SYSTEM SETUP
EFFECT/	+	FUNCTION
CH SEL

	ENTER		1-3	2 Use the 2´3 buttons to select the setting
NR	–	SELECT
DIGITAL		SIGNAL		you want, BYPASS or ADJUST.
	INPUT	DIRECT
MIDNIGHT	MULTI CH DSP	STEREO/
		/DTS
LIGHT	ADVANCED	STANDARD

ADJUST: Use the ADJUST setting when you want to be able to control each channel level individually.

AV PRE-PROGRAMMED AND LEARNING

REMOTE CONTROL UNIT

BYPASS: This setting is good for getting the cleanest possible signal. In this setting you won’t be able to change each channel individually.

We recommend using BYPASS and the default setting is

BYPASS.

3 Use the 5´° buttons to select EXIT.

Press the ENTER button.

You will return to the SYSTEM SETUP mode.

Multi Channel In Setting Using the Main Unit

You can also use the main unit to change the sound level of the MULTI CH IN. Follow the steps below.

STANDBY/ON MULTI CH INPUT

VSX-D909SDigital Signal Processor

DOWN UP

40

1Put receiver in the STANDBY mode.

2While holding down the MULTI CH

INPUT button press the

STANDBY/ON button.

The setting will change depending on what state the receiver was previously in. For a few seconds the display will show you which MULTI CH setting you are now in.

memo The default setting is BYPASS.