Extron electronic VLM 1000 Mount the receiver housing to the surface, If not using a raceway

Page 16

Installation — Stage 1, cont’d

4.Mount the receiver housing to the surface.

If not using a raceway:

Mount the receiver housing and base to the surface, using the appropriate screws for the type of surface. (Screws and wall anchors are not included.)

If using a raceway:

a.Position the receiver housing with the raceway inserted through the knockout.

b.Mount the receiver housing and base to the surface, using the appropriate screws for the type of surface. (Screws and wall anchors are not included.)

ÜMount the receiver housing to the mounting surface using screws.

ÁIf using a raceway, insert the raceway through the knockout, then mount the housing.

2-8 VoiceLift Microphone Installation • Installation — Stage 1

Image 16

Contents VoiceLift Microphone Precautions Safety Instructions EnglishConsignes de Sécurité Français Sicherheitsanleitungen DeutschVoiceLift Microphone installation and wiring overview VoiceLift Microphone Installation Introduction OverviewIntroduction Overview FCC Class B NoticeTypical classroom installation VoiceLift Microphone Installation Introduction PlanningIntroduction Planning Room layoutExample of a classroom installation Room configurationRoom considerations Introduction Planning, cont’d  The room is larger than 40 byInventory Introduction Inventory OverviewIncluded items  Bolts for concrete structural ceilings where needed Items not includedInstallation Overview VoiceLift Microphone Installation Installation OverviewStage 1 Install the VLR 102 Receiver Drop ceiling Stage 3 Configure and Test the SystemJunction box Wall or other hard surfaceVoiceLift Microphone Installation Installation Stage Installation StageDrop ceiling Junction box Wall or other hard surface Installing the Receiver in a Drop Ceiling Mount the receiver housing to the ceiling tileCut a hole in the ceiling tile Cut a hole in the ceiling tileAttach a conduit to the back plate if needed CAttach a conduit to the back plate if desiredInstalling the Receiver in a Junction Box Install the junction boxAttach the receiver housing to the junction box Attach a conduit to the junction box if neededInstall a raceway if needed Installing the Receiver in a Wall or Other Hard SurfaceMark the mounting screw locations on the surface If not using a raceway Mount the receiver housing to the surfaceIf using a raceway Where it goes Connects to the PVS 204 SA PoleVault switcher Receiver domeVoiceLift Adapter Ethernet cablePull the cables to the receiver ÇConnect the Ethernet cable to Receiver Out RJ-45 jackAttach the receiver dome to the housing Connect the cables to the receiverAttach the receiver dome to the housing Align the arrows on the housing rim and the dome tabPull cables to the PoleVault switcher Connect cables to the PoleVault switcherPoleVault switcher Runpole.the cables through the projectorConfigure the system Set up the microphoneÏSet up the microphone Test the systemFinish the installation Adjust the audio levelVoiceLift Microphone Installation Installation Stage 3 Walk around the room to check for sound qualityOptional Installation Example Instant Alert Insert the black wire into the Ground portConnect the receiver to the MLC 104 IP Plus Connect the communication cable to an MLC Digital I/O portConfigure the MLC 104 IP Plus Using Global Configurator, configure the MLC’sPress and hold both Volume buttons Test the instant alert notificationVoiceLift Microphone Installation Reference Information Specifications VLR 102 and VLR 102 SRReference Information General Specifications VLP 102 VoiceLift Microphone Audio/acoustic and electricalSpecifications VLC 102 Microphone Charging Station Configure the system. Set up the microphone Test the system. Stage 2 Connect the Receiver to the PoleVault System