Extron electronic VLM 1000, VLM 2000 manual Pull the cables to the receiver

Page 18

Installation — Stage 2, cont’d

1.Pull the cables to the receiver.

a.Pull the communication/power Ethernet cable through the receiver’s base, along with any other cables that will be attached to the receiver (RS-232, Ethernet cable to a secondary receiver, etc.)

b.If mounting to a wall and using a raceway, place the cables in the raceway and replace the raceway cover.

ÄPull the cable(s).

ÅPlace the cables in the raceway and replace the raceway cover.

a.Connect the Ethernet cable to the Receiver Out port (the RJ-45 connector on the left on the receiver base).

ÇConnect the Ethernet cable to the

Receiver Out RJ-45 jack.

2-10 VoiceLift Microphone Installation • Installation — Stage 2

Image 18

Contents VoiceLift Microphone Consignes de Sécurité Français PrecautionsSafety Instructions English Sicherheitsanleitungen DeutschIntroduction Overview VoiceLift Microphone installation and wiring overviewVoiceLift Microphone Installation Introduction Overview FCC Class B NoticeIntroduction Planning Typical classroom installationVoiceLift Microphone Installation Introduction Planning Room layoutRoom configuration Example of a classroom installationRoom considerations Introduction Planning, cont’d  The room is larger than 40 byIntroduction Inventory Overview InventoryIncluded items  Bolts for concrete structural ceilings where needed Items not includedInstallation Overview VoiceLift Microphone Installation Installation OverviewJunction box Stage 1 Install the VLR 102 Receiver Drop ceilingStage 3 Configure and Test the System Wall or other hard surfaceInstallation Stage VoiceLift Microphone Installation Installation StageDrop ceiling Junction box Wall or other hard surface Cut a hole in the ceiling tile Installing the Receiver in a Drop CeilingMount the receiver housing to the ceiling tile Cut a hole in the ceiling tileAttach a conduit to the back plate if needed CAttach a conduit to the back plate if desiredAttach the receiver housing to the junction box Installing the Receiver in a Junction BoxInstall the junction box Attach a conduit to the junction box if neededInstalling the Receiver in a Wall or Other Hard Surface Install a raceway if neededMark the mounting screw locations on the surface Mount the receiver housing to the surface If not using a racewayIf using a raceway VoiceLift Adapter Where it goes Connects to the PVS 204 SA PoleVault switcherReceiver dome Ethernet cablePull the cables to the receiver ÇConnect the Ethernet cable to Receiver Out RJ-45 jackAttach the receiver dome to the housing Connect the cables to the receiverAttach the receiver dome to the housing Align the arrows on the housing rim and the dome tabPoleVault switcher Pull cables to the PoleVault switcherConnect cables to the PoleVault switcher Runpole.the cables through the projectorÏSet up the microphone Configure the systemSet up the microphone Test the systemVoiceLift Microphone Installation Installation Stage 3 Finish the installationAdjust the audio level Walk around the room to check for sound qualityConnect the receiver to the MLC 104 IP Plus Optional Installation Example Instant AlertInsert the black wire into the Ground port Connect the communication cable to an MLC Digital I/O portPress and hold both Volume buttons Configure the MLC 104 IP PlusUsing Global Configurator, configure the MLC’s Test the instant alert notificationSpecifications VLR 102 and VLR 102 SR VoiceLift Microphone Installation Reference InformationReference Information General Specifications VLP 102 VoiceLift Microphone Audio/acoustic and electricalSpecifications VLC 102 Microphone Charging Station Configure the system. Set up the microphone Test the system. Stage 2 Connect the Receiver to the PoleVault System