Raymarine ST60 manual Important information, Safety notices, EMC conformance, Handbook information

Page 3

Prefacei

Preface

Important information

Safety notices

WARNING: Product installation & operation

This equipment must be installed and operated in accordance with the Raymarine instructions provided. Failure to do so could result in personal injury, damage to your boat and/or poor product performance.

WARNING: Electrical safety

Make sure you have switched off the power supply before you start installing this product.

WARNING:

Although we have designed this product to be accurate and reliable, many factors can affect its performance. Therefore, it should serve only as an aid to navigation and should never replace commonsense and navigational judgement. Always maintain a permanent watch so you can respond to situations as they develop.

EMC conformance

All Raymarine equipment and accessories are designed to the best industry standards for use in the recreational marine environment.

The design and manufacture of Raymarine equipment and accessories conform to the appropriate Electromagnetic Compatibility (EMC) standards, but correct installation is required to ensure that performance is not compromised.

Handbook information

To the best of our knowledge, the information in this handbook was correct when it went to press. However, Raymarine cannot accept liability for any inaccuracies or omissions it may contain.

In addition, our policy of continuous product improvement may change specifications without notice. Therefore, Raymarine cannot accept liability for any differences between the product and the handbook.

Image 3
Contents ST60 Wind Close Hauled Instrument Page Handbook information Safety noticesImportant information EMC conformanceST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Contents Installation Preface ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook ST60 Wind IntroductionSeaTalk Remote controlData inputs ST60 Close Hauled WindParts supplied Mounting optionsThese items are not with ST60 Close Hauled Wind Getting started Displayed informationPointer Digital display Normal operationUsing the disp key Tack AlarmsCanceling an alarm True/ApparentSetting alarm conditions Switching alarms on and offSetting alarm thresholds Display illumination Transducer MaintenanceServicing and safety InstrumentCabling TroubleshootingPreliminary procedures Fixing faultsHelp us to help you Technical supportWorld wide web Telephone help lineST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Planning your installation Site requirementsTransducers Instrument EMC installation guidelines Connections to Other Equipment ProcedureUnpacking Suppression FerritesSurface mounting Fitting the instrumentsFitting the low-profile bezel Flush mountingFlush mounting procedure Bracket Mounting Fitting transducers Typical windvane installationWind vane is typically mounted on a mast top, as follows Lower part of the clamp RotavectaGeneral Running transducer cableFrom masthead Connecting the instruments Signal connectionsTypes of connection SeaTalk systems Power supply connectionsStand alone instruments ST60 Wind & Close Hauled Wind Instrument Owner’s HandbookLinearizing and aligning the wind transducer User calibrationHold down Leaving User calibrationIntermediate calibration Dealer calibrationLeaving Intermediate calibration Response settings User calibration on/offWind speed Calibration Mode Boat show mode Factory defaultsLeaving Dealer calibration ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook TOP Page Shaded area to be removed Page Front