Raymarine ST60 manual Procedure, Unpacking, Suppression Ferrites, Connections to Other Equipment

Page 26

14

ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook

age the equipment, but may cause the loss of some information and may change the operating mode.

Raymarine specified cables are used. Cutting and rejoining these cables can compromise EMC performance and must be avoided unless doing so is detailed in the installation manual.

If a suppression ferrite is attached to a cable, this ferrite should not be removed. If the ferrite needs to be removed during installation it must be reas- sembled in the same position.

Suppression Ferrites

The following illustration shows typical cable suppression ferrites used with Raymarine equipment. Always use the ferrites supplied by Raymarine.

D3548-6

Connections to Other Equipment

If your Raymarine equipment is to be connected to other equipment using a cable not supplied by Raymarine, a suppression ferrite MUST always be attached to the cable near the Raymarine unit.

3.2 Procedure

As it is not possible to describe procedures for all possible installation scenarios, the procedures given here describe the broad requirements for installing wind transducers and ST60 Wind instruments. Adapt these procedures as appropriate, to suit your individual requirement.

CAUTION:

Where it is necessary to cut holes (e.g. for cable routing and instrument mounting), ensure that these will not cause a hazard by weakening critical parts of the vessel’s structure.

Unpacking

Unpack your ST60 instrument and check that the items described in the Preface are present:

Image 26
Contents ST60 Wind Close Hauled Instrument Page EMC conformance Safety noticesImportant information Handbook informationST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Contents Installation Preface ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Introduction ST60 WindST60 Close Hauled Wind Remote controlData inputs SeaTalkMounting options Parts suppliedThese items are not with ST60 Close Hauled Wind Pointer Getting startedDisplayed information Normal operation Digital displayUsing the disp key True/Apparent AlarmsCanceling an alarm TackSetting alarm thresholds Setting alarm conditionsSwitching alarms on and off Display illumination Instrument MaintenanceServicing and safety TransducerFixing faults TroubleshootingPreliminary procedures CablingTelephone help line Technical supportWorld wide web Help us to help youST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Transducers Planning your installationSite requirements Instrument EMC installation guidelines Suppression Ferrites ProcedureUnpacking Connections to Other EquipmentFitting the instruments Surface mountingFlush mounting Fitting the low-profile bezelFlush mounting procedure Bracket Mounting Typical windvane installation Fitting transducersWind vane is typically mounted on a mast top, as follows Rotavecta Lower part of the clampRunning transducer cable GeneralFrom masthead Types of connection Connecting the instrumentsSignal connections Power supply connections SeaTalk systemsST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Stand alone instrumentsUser calibration Linearizing and aligning the wind transducerLeaving User calibration Hold downLeaving Intermediate calibration Intermediate calibrationDealer calibration Wind speed Response settingsUser calibration on/off Calibration Mode Leaving Dealer calibration Boat show modeFactory defaults ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook TOP Page Shaded area to be removed Page Front