Raymarine ST60 manual Bracket Mounting

Page 30

18	ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook

•There is sufficient space behind the location to accommodate the rear of the instrument and connectors.

3.Apply the flush mount template (supplied at the rear of this handbook) to the selected location and mark out the aperture into which the assembled instru- ment and bezel will sit.

4.Cut out the aperture (3) for the assembled instrument and bezel and remove the template.

5.Peel off the protective sheet from the self-adhesive gasket (4) then stick the gasket into position on the rear of the bezel.

	1	3	1	5	6	5
Flush mounting	4
Flush mounting						D4307-3
						D4307-3

6.Screw the two fixing studs (1) into the threaded sockets on the rear of the instrument.

7.Mount the assembled instrument, studs, bezel and gasket into the panel.

8.Locate the flush mount bracket (6) onto the fixing studs and secure the assem- bly to the panel with the thumb-nuts (5).

Bracket Mounting

A Control Unit Mounting Bracket (Part No. E25009) enables you to mount your ST60 instrument in locations where other forms of mounting are impractical.

Image 30

Contents ST60 Wind Close Hauled Instrument Page EMC conformance Safety noticesImportant information Handbook informationST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Contents Installation Preface ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Introduction ST60 WindST60 Close Hauled Wind Remote controlData inputs SeaTalkMounting options Parts suppliedThese items are not with ST60 Close Hauled Wind Getting started Displayed informationPointer Normal operation Digital displayUsing the disp key True/Apparent AlarmsCanceling an alarm TackSetting alarm conditions Switching alarms on and offSetting alarm thresholds Display illumination Instrument MaintenanceServicing and safety TransducerFixing faults TroubleshootingPreliminary procedures CablingTelephone help line Technical supportWorld wide web Help us to help youST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Planning your installation Site requirementsTransducers Instrument EMC installation guidelines Suppression Ferrites ProcedureUnpacking Connections to Other EquipmentFitting the instruments Surface mountingFlush mounting Fitting the low-profile bezelFlush mounting procedure Bracket Mounting Typical windvane installation Fitting transducersWind vane is typically mounted on a mast top, as follows Rotavecta Lower part of the clampRunning transducer cable GeneralFrom masthead Connecting the instruments Signal connectionsTypes of connection Power supply connections SeaTalk systemsST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Stand alone instrumentsUser calibration Linearizing and aligning the wind transducerLeaving User calibration Hold downIntermediate calibration Dealer calibrationLeaving Intermediate calibration Response settings User calibration on/offWind speed Calibration Mode Boat show mode Factory defaultsLeaving Dealer calibration ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook TOP Page Shaded area to be removed Page Front