Raymarine ST60 manual Calibration

Page 43

	Chapter 4: Calibration				31
	Hold down		and	true	for approximately 12 seconds
	Hold down	disp	and	app	for approximately 12 seconds
		disp		app

Entry screen

CAL

TRUE APP

	Press vmg and	tack momentarily
	CAL	Press
	User calibration	vmg or tack
	on/off	vmg or tack
	on/off
	TRUE	to toggle User calibration
	TRUE	APP
		either on (UC1) or off (UC0)
	disp

CAL

Wind angle response

TRUE APP

disp

CAL

Wind speed response

TRUE APP

disp

Press

vmg or tack

to set required response

(A1) to (A15)

Press

vmg or tack

to set required response

(S1) to (S15)

CALVMG

VMG response

TRUE APP

disp

go to sheet 2

Press

vmg or tack

to set required response

(1) to (15)

Dealer calibration - sheet 1	D4317-3

Image 43

Contents ST60 Wind Close Hauled Instrument Page Handbook information Safety noticesImportant information EMC conformanceST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Contents Installation Preface ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook ST60 Wind IntroductionSeaTalk Remote controlData inputs ST60 Close Hauled WindParts supplied Mounting optionsThese items are not with ST60 Close Hauled Wind Displayed information Getting startedPointer Digital display Normal operationUsing the disp key Tack AlarmsCanceling an alarm True/ApparentSwitching alarms on and off Setting alarm conditionsSetting alarm thresholds Display illumination Transducer MaintenanceServicing and safety InstrumentCabling TroubleshootingPreliminary procedures Fixing faultsHelp us to help you Technical supportWorld wide web Telephone help lineST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Site requirements Planning your installationTransducers Instrument EMC installation guidelines Connections to Other Equipment ProcedureUnpacking Suppression FerritesSurface mounting Fitting the instrumentsFitting the low-profile bezel Flush mountingFlush mounting procedure Bracket Mounting Fitting transducers Typical windvane installationWind vane is typically mounted on a mast top, as follows Lower part of the clamp RotavectaGeneral Running transducer cableFrom masthead Signal connections Connecting the instrumentsTypes of connection SeaTalk systems Power supply connectionsStand alone instruments ST60 Wind & Close Hauled Wind Instrument Owner’s HandbookLinearizing and aligning the wind transducer User calibrationHold down Leaving User calibrationDealer calibration Intermediate calibrationLeaving Intermediate calibration User calibration on/off Response settingsWind speed Calibration Mode Factory defaults Boat show modeLeaving Dealer calibration ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook TOP Page Shaded area to be removed Page Front