Raymarine ST60 manual Mode

Page 44

32	ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook

from sheet 1

Press

vmg or tack

to select Cal factor screen

Wind	CAL
Wind
speed
		KTS
	TRUE	APP

timeout

			Setting wind speed
	Wind speed
	calibration		Use
	CAL		Use
			vmg or tack
	TRUE	APP	to set the calibration factor
	TRUE	APP	to 0.7
			to 0.7

disp

CAL
Boat show
mode
TRUE	APP
	disp

Press

vmg or tack

to set to off (bS0)

Do NOT set to on (bS1)

Factory defaults

CAL

Press

vmg or tack

TRUE		APP	to either apply factory defaults
			or retain current settings
			(F1 = factory defaults, F0 = current settings)
	Press	true
	and	true
disp	and	app
disp		app

to exit calibration

Dealer calibration - sheet 2

D4318-2

Image 44

Contents ST60 Wind Close Hauled Instrument Page Safety notices Important informationEMC conformance Handbook informationST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Contents Installation Preface ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Introduction ST60 WindRemote control Data inputsST60 Close Hauled Wind SeaTalkMounting options Parts suppliedThese items are not with ST60 Close Hauled Wind Pointer Getting startedDisplayed information Normal operation Digital displayUsing the disp key Alarms Canceling an alarmTrue/Apparent TackSetting alarm thresholds Setting alarm conditionsSwitching alarms on and off Display illumination Maintenance Servicing and safetyInstrument TransducerTroubleshooting Preliminary proceduresFixing faults CablingTechnical support World wide webTelephone help line Help us to help youST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Transducers Planning your installationSite requirements Instrument EMC installation guidelines Procedure UnpackingSuppression Ferrites Connections to Other EquipmentFitting the instruments Surface mountingFlush mounting Fitting the low-profile bezelFlush mounting procedure Bracket Mounting Typical windvane installation Fitting transducersWind vane is typically mounted on a mast top, as follows Rotavecta Lower part of the clampRunning transducer cable GeneralFrom masthead Types of connection Connecting the instrumentsSignal connections Power supply connections SeaTalk systemsST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Stand alone instrumentsUser calibration Linearizing and aligning the wind transducerLeaving User calibration Hold downLeaving Intermediate calibration Intermediate calibrationDealer calibration Wind speed Response settingsUser calibration on/off Calibration Mode Leaving Dealer calibration Boat show modeFactory defaults ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook TOP Page Shaded area to be removed Page Front