Fostex D-160 Program Change procedure, Use the JOG dial to select a desired Program

D-160 Owner's Manual (Recording /Playback)

2-2. Program Change

The Program Change function allows you to manage multiple Programs that were setup according to the procedure mentioned above for the recording, playback, or editing of the individual Programs. The D-160 needs to be in the Program Setup mode to perform the Program Change function.

The following example assumes that ten Programs (P01 - P10) have already been setup.

Program Change procedure

1.Press the STORE key while holding down the HOLD/> key.

The D-160 will enter the Program Setup mode, and displays “Select PGM!”, and then the current Program number and title.

2.Use the JOG dial to select a desired Program.

Rotating the JOG dial back and forth will change the Program number on the display to a smaller or larger number.

For example, rotating the JOG dial counter-clockwise when P03 is selected will change the Program number on the display as follows: P03 --> P02 --> P01. Rotating the JOG dial clockwise will change the Program number as follows: P03 --> P04 --> P05 ..... --> P10 --> New Program?.

If you wish to setup a new Program, select the “New Program?” indication.

P01

P02

P03

P08

P09

P10

New Program?

Current Program

A selected Program uses the Time Base (ABS, MTC, or BAR/BEAT/CLK) that was used for the Program previously. To change the Time Base, press the DISP SEL key while holding down the EXECUTE/YES key. You can set the Time Base for each Program. Pressing the DISP SEL key will display the REMAIN indication. Use this indication to check to see if any available recording time (or bars) remains. This remaining time is not the time for the corresponding Program, but the total amount of time that can be used by all Programs. Bear in mind that the REMAIN indication is based on the mono track calculation.

<Note>

1. The following parameters can be set for each Program individually:

Memory data (CLIPBOARD IN/OUT, AUTO RTN START/END, AUTO PUNCH IN/OUT)

Time Base (ABS, MTC, or BAR/BEAT/CLK)

SETUP mode:

*Time signature setting (BAR BEAT), * TEMPO setting, * CLICK ON/OFF setting,

*PREROLL TIME setting, * MIDI SYNC OUT setting, * MTC FRAME RATE setting,

*MTC OFFSET setting, * MTC OFFSET MODE setting, * REC PROTECT ON/OFF setting,

*SLAVE MODE ON/OFF setting, * SLAVE TYPE setting, * FS (Sampling frequency) setting

2. The following parameters are common to all Programs:

Auto Play mode ON/OFF, Auto Return mode ON/OF, Vari-pitch mode ON/OFF, Pitch data

SETUP mode:

*DIGITAL IN setting, * DIGITAL OUT setting, * BAR/BEAT RESOLUTION ON/OFF setting,

*DEVICE ID setting

50