
Setting the DMT-8 Ver. 2 (Slave)
# Refer to the
1.Use the same frame rate as the
2.Use the
There is no “MTC offset mode setting” on the
3.Set the “MIDI device ID setting” in Setup mode to “01” on the
4.Set the Slave mode to “On” for the “Slave mode setting” in the Setup mode.
You can set the Slave mode on the
5.Press the DISP SEL key while holding down the EXECUTE/YES key to select MTC as the Time Base indication.
<Note>
After this setting, check the following items on the
*“LOCKED” LED is flashing: When the Chase Lock operation is complete, this indicator will light.
*“DIGITAL” lights on the display: The unit is syncing to the external digital signal.
<Note>
Do not connect or remove the optical cable the DATA IN connector while
Slave mode is on. This can generate noise, affecting the connected external devices.
Checking Chase Lock
1.When the master device
Check to make sure the display shows the correct MTC time.
2.When you start recording on the master device, the slave device will start recording after the Chase Lock operation is complete.
3.When you stop the master device, the MTC transmission from the master device will be interrupted and the slave machine will also stop.
The illuminated “PLAY” button's lamp will begin to flash.
4.While the master device is in fast forward or rewind mode, the slave machine will remain stopped.
When you start playing or recording on the master device, the slave machine will start the Chase Lock operation.
<Note>
The
*If the Chase Lock operation or control is incorrect, check all connections, cables, and settings.