Fostex D-160 owner manual Midi Sync Signal Output Setting Midi Sync Out ?, 150

D-160 Owner's manual (SETUP mode)

2-8. MIDI Sync Signal Output Setting (“Midi Sync Out ?”)

This mode sets up the type of MIDI sync signal for external MIDI equipment.

The type of signal the D-160 outputs is either MIDI Clock & Song Position Pointer or MTC (MIDI Time Code). Choose one so that the external MIDI equipment can recognize it when synchronizing to the D-160.

In case of the MIDI Clock & Song Position Pointer, you need to set the section "2-2. Time Signature" and section "2-3.Tempo as previously mentioned."

In case of the MTC ( MIDI Time Code), you need to set the section "2-9. MTC Frame Rate", "2-10. MTC Offset Time" and "2-11. MTC Offset Mode" described below.

* See page "117" “MIDI Synchronization Function” for details of the MIDI sync.

<Note>

The D-160 will still run the time counter in PLAY mode even after the ABS END. Thus, it will continue generating the MIDI Clock & Song Position Pointer and MTC even if you have not recorded anything, provided a tempo map has been set up.

*Initial setting : CLK

*Available setting : CLK, MTC, Off

Clock : MIDI Clock & Song Position Pointer, MTC : MIDI Time Code

*This setting is applicable song by song.

*This setting can be saved or loaded as a part of the song data.

*The setting is memorized even when the power is off.

*Make sure to choose the right program before setting up this mode.

1.Press the DISP SEL key and choose the flashing SETUP mode on the display. Then, press the EXECUTE/YES key.

The SETUP display will stop flashing.

2.With the JOG dial, choose “MidiSyncOut?”.

The “?” display will start flashing. The display will also show the current setting. In the case of initial setting, it will show CLK.

3.Press the EXECUTE/YES key.

The current setting will start flashing “**” which indicates it is ready to change setting.

																SETUP
OL
0
3
6																44.1kHz
9
12
18
24
30
42
∞
_	1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16

4.With the JOG dial, enter a required Midi Sync Signal.

Choose the type of MIDI signal you want.

If you choose “CLK”, the D-160 generates the MIDI Clock & Song Position Pointer. If you choose “MTC”, the D-160 generates the MIDI Time Code.

If you choose “Off”, the D-160 generates no MIDI Sync signal.

5.Press the EXECUTE/YES key after you have entered the Midi Sync Signal you wanted.

The setting will be registered and the display will go back to step 2 above.

*Press either the “STOP” button or EXIT/NO key to return from the second step menu to the first or to quit SETUP mode. The menu will go backwards each time you press either key so that you can correct the setting, choose some other SETUP mode or eventually return to the normal time base display.

150