Fostex owner manual 118, Setup of D-160, Confirming the Midi clock sync

D-160 Owner's Manual (MIDI sync function)

Setup of D-160

1. Because the MIDI clock and song position pointer will be output from the D-160, set the SETUP

mode "MIDI sync signal output setting" to "CLK."

*Initial setting: CLK

*Permissible setting: CLK (MIDI clock and song position pointer:"CLK") / MTC (MIDI time code: "MTC") / Off (No output of MIDI sync signal)

*This item can be setup for each program.

*The setting can be saved/loaded as song data.

*This setting will be held even though power is switched OFF.

#Refer to page "150", SETUP mode "2-8. MIDI sync signal output setting" for correct operating procedures.

2. The meter in the desired bar can be set by "Time signature setting" of the SETUP mode.

*Initial setting: 001 bar, 4/4 signature.

*Permissible bar setting: 001~999

*Permissible meter setting: 1/4, 2/4, 3/4, 4/4, 5/4, 1/8, 3/8, 5/8, 6/8, 7/8, 8/8, -- -- (Elimination of signature)

*Permissible setting of maximum number of points: 64 points

*This item can be set for each program.

*The setting can be saved/loaded as song data.

*This setting will be held even though power is switched OFF.

# Refer to page "143", SETUP mode "2-2. Time Signature Setting" for operating procedure.

3. Tempo in the desired bar can be set by "Tempo setting" of the SETUP mode.

Tempo map is made in steps 2 and 3.

*Initial setting: 001 bar, 1st meter, Tempo120.

*Permissible bar setting: Follows the previous "Setup of the time signature."

*Permissible signature setting: Follows the previous "Setup of the time signature."

*Permissible setting of tempo: Quarter note=30~250 .... (Tempo elimination)

*Permissible setting of maximum number of points: 64 points

*This item can be set for each program.

*The setting can be saved/loaded as song data.

*This setting will be held even though power is switched OFF.

# Refer to page "145", SETUP mode "2-3. Tempo Setting" for operating procedure.

4. Set the SETUP mode "Metronome setting" to ON if click sound is to be output according to the

setup tempo map.

*Initial setting: Off

*Permissible setup item: Off, On

*This item can be set for each program.

*The setting can be saved/loaded as song data.

*This setting will be held even though power is switched OFF.

# Refer to page "148", SETUP mode "2-6. Metronome setting" for operating procedure.

5. Press the DISP SEL key while pressing the EXECUTE/YES key, and then change the time base

display to BAR/BEAT/CLK.

Confirming the MIDI clock sync

During recording and at playback following the recording, the time base (BAR/ BEAT/CLK) is displayed in accordance to the setup tempo map, and the MIDI clock and song position pointer is also output.

Confirm that the travel position (BAR/BEAT/CLK) of the D-160 and the travel position of the synchronized MIDI sequencer are matched.

118