Fostex D-160 owner manual Copy & Paste, Copying, Entering and storing the Clipboard in point

D-160 Owner's Manual (Edit function)

1. Copy & Paste

The Copy & Paste functions use the clipboard of the D-160, allowing you to copy sound data and paste it to the specified area. The copied data remains on the clipboard after you paste it, and you can paste the same data as many times as you want to different places. The Copy & Paste functions can reference any one of the following time bases: ABS time, MTC time, MIDI Bar/Beat/Clock.

*To perform the Copy operation, you first need to set the start point (Clipboard In point) and the end point (Clipboard Out point) of the copied data and the copy source track.

To perform the Paste operation, you need to set the start point (Auto Punch In point) and the paste destination point.

<Note-1>

The data on the Clipboard will be replaced by new data each time you press the COPY key of the MOVE key.

<Note-2>

If pasted data overlaps the source data, the content of the source data will be altered.

1-1. Copying

First, you need to specify the area to be copied (using the Clipboard In/ Out points and copy track).

*The following procedure is based on data with the ABS Time Base.

To change the Time Base to MTC or MIDI BAR/BEAT/CLK, press the DISP SEL key while pressing and holding down the EXECUTE/YES key.

*Before you start work, restore the default settings on the D-160.

*Do not change Programs or sampling rates until a session is complete.

PUNCH IN / OUT

DIGITAL MULTITRACK RECORDER D-160

				RECORD TRACK
1/9	2/10	3/11	4/12	5/13	6/14	7/15	8/16	SHIFT
		LOCKED		HD ACCESS		MTC IN

1, 3								3, 6
		4, 6
AUTO RTN
	CLIPBOARD			AUTO PUNCH				EXECUTE	EXIT
AUTO PLAY	IN	OUT	START	IN	OUT	END	DISP SEL	/YES	/NO
				AUTO RTN			TIME BASE SEL
COPY	MOVE		PASTE	ERASE	UNDO	REDO	HOLD/	STORE	RECALL

AUTO				PGM CHANGE	1, 4
PUNCH	REHEARSAL		LOCATE	VARI PITCH
	TAKE
RECORD	STOP	PLAY	REWIND	F FWD
	CLIPBOARD PLAY
	LOCATE ABS 0
	LOCATE ABS END

7 8 2, 5

Entering and storing the CLIPBOARD IN point

1.Press the RECALL key, and then the CLIPBOARD IN key (or press only the CLIPBOARD IN key). The D-160 will enter the edit mode.

2.Move the cursor to the digit you wish to change using the HOLD/> key or the SHUTTLE dial, and change the value using the JOG dial.

86