Fostex D-160 Preroll Time Setting Preroll Time ?, 149, With the JOG dial, choose Preroll Time?

D-160 Owner's manual (SETUP mode)

5.Press EXECUTE/YES key after choosing the setting you want.

*Press either the "STOP" button or EXIT/NO key to return from the second step menu to the first or to quit SETUP mode. The menu will go backwards each time you press either key so that you can correct the setting, choose some other SETUP mode or eventually return to the normal time base display.

2-7. Preroll Time Setting ("Preroll Time ? ")

The D-160 has a preroll function, which stops at the backwards specified time location. This function is useful when you want to start monitoring the recorded audio from just before a locate point.

Locate Point

Locate

Locate

Stop Point	You can set 'backwards specified locate point.
* Initial setting : 00sec
* Available setting : 00	~ 10sec in 1sec step

*The setting is applicable song by song.

*The setting can be saved or loaded as a part of the song data.

*The setting is memorized even when the powering off.

*Make sure to choose the right program before setting up this mode.

1.Press the DISP SEL key and choose the flashing SETUP mode on the display. Then, press the EXECUTE/YES key.

The SETUP display will stop flashing.

2.With the JOG dial, choose “Preroll Time?”.

The “?” display will start flashing. The display will also show the current setting. In the case of initial setting, it will show 00 second.

3.Press the EXECUTE/YES key.

The current setting will start flashing “**” which indicates it is ready to change setting.

SETUP

OL

0

3

6

944.1kHz

12

18

24

30

42

∞

_ 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

4.With the JOG dial, enter the required preroll time.

You can set the preroll time between 0 and 10 sec in 1 second steps.

If you turn the JOG dial clockwise, the time value will increase. And if you turn the JOG dial counter clockwise, the time value will decrease vise versa.

5.Press the EXECUTE/YES key after you have entered the preroll time you want.

The setting will be registered and the display will go back to the Item 2 above.

*Press either the “STOP” button or EXIT/NO key to return from the second step menu to the first or to quit the SETUP mode. The menu will go backwards each time you press either key so that you can correct the setting, choose some other SETUP mode or eventually return to the normal time base display.

149