Fostex D-160 owner manual Example Select PGM! -P02, Erasing specific data Program erase, 101

D-160 Owner's Manual (Edit function)

3-5. Erasing specific data (Program erase)

Here, erase all data recorded in any program that is no longer necessary.

Unlike the "erasing the program" explained in "Recording/Playback", the program number will remain intact and other settings will all be in the initial state same as when the New Program was made (at completion of erase, ABS 0=ABS END).

Therefore, the tempo map setting and program title will be in the initial figures.

<Note>

Note that the UNDO/REDO function cannot be used at Program Erasing.

4

	D-160	AUTO RTN
DIGITAL MULTITRACK RECORDER			CLIPBOARD			AUTO PUNCH				EXECUTE	EXIT
		AUTO PLAY	IN	OUT	START	IN	OUT	END	DISP SEL	/YES	/NO
						AUTO RTN			TIME BASE SEL
		COPY	MOVE		PASTE	ERASE	UNDO	REDO	HOLD/	STORE	RECALL

PUNCH IN / OUT

				RECORD TRACK
1/9	2/10	3/11	4/12	5/13	6/14	7/15	8/16
		LOCKED		HD ACCESS		MTC IN

AUTO	REHEARSAL
PUNCH			LOCATE
	TAKE
RECORD	STOP	PLAY	REWIND
SHIFT
	CLIPBOARD PLAY
	LOCATE ABS 0
	LOCATE ABS END
			3

VARI PITCH

F FWD

PGM CHANGE

2

1

1. Press the STORE key while holding down the HOLD/> key.

The D-160 will enter the Program Setup mode, and display the message “Select PGM!”, and then the current Program number and title. (The Program number and “SURE?” will flash.)

Example: “Select PGM!” ->“P02 [*****”

(02 flash, 02 is the current program number)

2.Turn the JOG dial to select the number of a Program you wish to erase.

The selected Program number will flash. (Can not use "New Program?.")

3.Press the ERASE key.

The message “Erase PGM**?” (where, ** is the selected Program number) appears on the display, and “SURE?” will flash.

4.Press the EXECUTE/YES key.

When the erase operation is completed, the display changes to the “Title Edit PGM**?” menu in Setup mode, where you can name the Program from which you erased the data.

*To name the Program, follow the explanation on page "147" regarding the “2-4. Title Edit PGM?” menu in Setup mode.

If you do not wish to name the Program, press the STOP button or the EXIT/NO key. The display will change to the ABS indication, with the Program number unchanged. The title of the Program is erased, and the Program will use a temporary title.

101