Fostex D-160 owner manual Data Type, 177

	D-160 Owner's Manual (MMC/FEX List/Maintenance/Specifications)
Data Type
<loop op . mode>	12=stop
	Indicates the next operating mode following locating to the start point (GP1) upon
	arriving at the end point (GP6) by the play mode.
	In D-160, 12=stop only is effective.
<post locate mode>	12=stop
	15=play
	Specifies operating mode in which D-160 should enter upon completing the
	locate operation. Corresponds to the setting of AUTO PLAY ON ("15")/OFF ("12") on
	the main unit.
<count>	01~7F
	Specifies succeeding data byte numbers.
<mmc track>	Complies to the MMC (MIDI MACHINE CONTROL) standard track bit map.
	In D-160, you always need to specify three byte combinations of "r0", "r1" and "r2."
<edit message>	00 = no message
	01	= completed (completion flag)
	02	= active (execution flag)
	02<mmc time> = Indicates unprocessed time by active (execution flag) and <mmc
	time>.
	02<count><mmc track> = Indicates source track by active (execution flag) and
	<mmc track>. Used for clipboard play.
	03	= cancel (execution stop)
	05	= Indicates rehearsal (rehearsal mode of auto rec). Possible of undo.
	06	= Indicates take (take mode of auto rec). Possible of undo.
	10	= over value error
	10	<mmc time> = Capacity shortage time is indicated by over value error (error by
	capacity shortage) and <mmc time>. In copy paste, it indicates capacity shortage
	time required for a minimum one time paste.
	11	= Indicates in point error (incorrect in point).
	12	= Indicates out point error (incorrect out point).
	14	= Indicates void data (data necessary for paste does not exist).
	18	= Indicates track select error (track necessary to execute copy/move or erase/cut
	is not correctly setup).
	19<repeat count> = Indicates repeat number error and repeat numbers executable
	by <repeat count>.
	1A = Indicates disable rec (record disable mode).
	71	= Indicates on.
	72	= Indicates off.
<mmc time>	hr mn sc fr {ff/st} complies to the MMC standard time code.
<on/off>	70 = default
	71	= on
	72	= off
<repeat count>	01~7F
	Especially when executing commands such as paste, the number of pasting times to
	be continuously repeated following the auto punch in point is specified.
<channel>	1~18, 7F
	Select recorder tracks 1~18. "00" in particular, is not specified (default setting). "7F"
	indicates input/output of Adat optical. For details, refer to explanation on setting
	the Command/Mode.
<lock enable>	00 = lock disable, chase disable
	01	= lock enable, chase enable
	Corresponds to SLAVE ON ("01")/OFF ("00") in the main unit.
<lock status>	00 = lock disable, chase disable
	01	= lock enable (unlocked), chase enable (unlocked)
	11	= lock enable (locked), chase enable (locked)
<program>	01~63H
	Indicates program numbers (P1~P99) on the main unit. However, D-160 can specify
	only 01 (corresponds to P1)~63H (corresponds to P99).
<lock mode>	40 = Free
	42	= Vari
	45	= SP DIF
	46	= adat
	Indicates the slave mode when this equipment is set to slave ON.

177