Fostex D-160 Bar/Beat Resolution Mode Setting Resolution?, With the JOG dial, choose Resolution?

D-160 Owner's manual (SETUP mode)

* All the analog output tracks are available regardless of the above settings.

2-17. Bar/Beat Resolution Mode Setting (“ Resolution?”)

This mode sets up the display resolution mode in either “ON” or “OFF”.

If you set this mode to “ON”, the D-160 will register the memory points rounding up or down so that clock digits are always kept at 00. This mode is only relevant when you choose Bar/Beat/Clock as a time base.

This function is very useful for edit functions such as copy paste or move paste when you use the Bar/Beat/Clock as the time base. For example, when you register a memory point that picks up a real time in play mode, you press the STORE button and then some memory keys. The position you choose will be automatically corrected based on the Bar/ Beat resolution. The position will always register in clock accuracy. This setting is memorized even when the power is off.

*For example, if you are to register 001 Bar 1 Beat 46 Clock to the CLIP BOARD IN point and 002 Bar 4 Beat 51 Clock to the CLIP BOARD OUT point, if the resolution mode is set, the actual memory will be corrected in the following key. This example is mentioned based on the time signature of a 4/4 Beat.

001 Bar 1 Beat 46 Clock -> 001 Bar 1 Beat 00 Clock : round down on clock 002 Bar 4 Beat 51 Clock -> 003 Bar 1 Beat 00 Clock : round up on clock

*Initial setting : Off

*Available setting : Off, On

*This setting is commonly applicable to all the programs.

*This setting cannot be saved or loaded.

*The setting is memorized even when the power is off.

1.Press the DISP SEL key and choose the flashing SETUP mode on the display. Then, press the EXECUTE/YES key.

The SETUP display stops flashing.

2.With the JOG dial, choose “ Resolution?”.

The “?” display will start flashing. The display will also show the current setting. In the case of the initial setting, it will show “Off”.

3.Press the EXECUTE/YES key.

The current setting will start flashing which indicates it is ready to change setting.

																SETUP
OL
0
3
6																44.1kHz
9
12
18
24
30
42
∞
_	1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16

4.With the JOG dial, choose either “On” or “Off”.

If you choose “Off”, the slave function will not work.

If you choose “On”, the clock will be rounded up or down always ending in 00.

5.Press EXECUTE/YES key after choosing the setting you want.

The display will go back to the display of item 2.

*Press either the STOP button or EXIT/NO key to return from the second step menu to the first or to quit SETUP mode. The menu will go backwards each time you press either key so that you can correct the setting, choose some other SETUP mode or eventually return to the normal time base display.

160