
*If you have selected a Program that has the Program number and title indication, plus “nD” (n=number) on the display:
e.g.: P01[********** ]2D (***** is title)
This indication means that saving Program 01 requires multiple SCSI disks. “2D” in this example means that two disks are required.
When using the hard disk, if the program data to be saved is larger than the hard disk capacity, "- ***MB" (insufficient capacity) will be displayed.
Also, if the EXECUTE/YES key is pressed while this is on the diaplay, "DISK FULL" will appear in the display.
7.Press the EXECUTE/YES key. (“SURE?” flashes.)
The
*If you have selected a Program that requires only one disk to save:
The current Song number (“S01”) in the SCSI disk appears on the display.
Pressing the EXECUTE/YES key at this point will start the save operation. “REMAIN” will light up, then the
*If you have selected a Program that requires multiple disks:
The save operation will start right away. “REMAIN” will light up, then the
When saving to the first disk is complete, “Insert Disk 2” (Insert the second disk!) appears on the display, and the
Pressing the STOP button or the EXIT/NO key will turn the “COMPLETED!” indication off.
<Notes>
*You cannot abort a save operation on the SCSI device while it is in progress.
*To enter a title for a SCSI disk, go to
*If you try to save data to multiple disks or try to save all Program data to one disk, and if those disks already have data recorded, the message (“B01[*****]DEL” or “S01[*****]DEL”) will appear on the display, asking if you wish to erase the Backup data or Song data already recorded on the disk, and “SURE?” will flash.
Subsequently, if you wish to erase the data, press the EXECUTE/YES key is and save will start after erasing the data. If you do not want to erase the data, rotate the JOG dial and select "Eject" while "SURE?" is blinking, and then press the EXECUTE/YES key and remove the disk. The disk can also be removed after emerging from the SETUP mode by pressing the STOP button or the EXIT/NO key. In this case, the press the EXIT/NO key while pressing down on the STOP button when in other than the SETUP mode.
Saving all Programs (Save ALL)
1.Follow Steps 1 through 5 of the “Saving an individual Program” procedure.
2.Use the JOG dial to select “Save ALL?” (“?” flashes.).
Selecting “Save All?” will cause the following display to appear.