Elation Professional 575E manual Channel 3 to 164 256+164=420

Design Spot 575E™

and channel 3 to "164" (256+164=420).

4.Wait for approximately 20 seconds for the unit to complete the address reset function.

B.Run if no DMX – This function dictates how the fixture will function if it looses DMX signal during normal operation. The default function is set to hold, in which the fixture will lock into the last DMX signal it received and remain in that position until it is turned off or begins receiving a new DMX signal. If the fixture is turned on without any DMX signal, the fixture will automatically go in to sound-active mode. Available settings are: “Close” – Shutter flags will close. “Hold” – Fixture will remain at it’s last settings. “Auto”

– Fixture will go into stand-alone mode, running the built-in program. “Music”

– The fixture will go into sound-active mode.

C.Pan Reverse - This function allows you to invert all pan movements. Use the Up and Down buttons to turn this function On and Off. Press the Enter button to accept the change or the Mode button to cancel and return to the main menu.

D.Tilt Reverse - This function allows you to invert all tilt movements. Use the Up and Down buttons to turn this function On and Off. Press the Enter button to accept the change or the Mode button to cancel and return to the main menu.

E.Fine resolution – This function changes the DMX channel operation from 8bit to 16bit.

F.Pan Degree – This function changes the maximum Pan resolution from either 540˚ or 630˚. The default function is 540˚.

G.Feedback – This function turns the feedback correction on or off. This function is set to on as default.

©Elation Professional®	29
	Design Spot 575E™