Yamaha 101 manual Assigning the Input Signal to a Track

Page 11

The Input Setting popup window will appear.

2.While playing the instrument, turn the GAIN knob up to adjust the input level. The meter on the right hand side of the Input Setting screen should be around the –12 to -6 dB mark when the instrument is at its maximum level.

Once you reach the 0 dB mark the signal will become distorted. Setting the input level at around -12 to -6 allows for changes in dynamics during live performance.

4.Turn the MONITOR/PHONES knob up to the desired listening level.

Assigning the Input Signal to a Track

1.In the Quick Navigate section press the [RECORD] key until the DIRECT page of the RECORD screen is displayed.

The [INPUT SEL] keys and the [TRACK SEL] keys will now be red and blinking.

2.Press the [INPUT SEL] key for the input channel that you are going to record from.

The [INPUT SEL] that was pushed will now be solid red, and the remaining [INPUT SEL] keys will no longer be blinking.

8

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Recording AW16G Recording 101 Table of Contents Recording the Stereo Track Creating an Audio CD Glossary Introduction AW16G FeaturesConnect the Monitoring System Setting up the AW16GWith Powered Monitors With Headphones Connect the instruments or microphones With Unpowered MonitorsXLR To TRS Cable Turn the Equipment on Creating a New Song RecordingSetting the Input Level Assigning the Input Signal to a Track Punch In/Out Recording the First TrackOverdubbing Disengaging a track from being record-enabledOverdubbing Additional Tracks Mixdown Setting the Basic Levels Adjusting the Panning Panning Guidelines Using the EQ Library Adjusting the EQUsing the Dynamic Processor Library Using the Dynamics ProcessorsRecalling a Preset on an Effects Processor Using the Internal Effects ProcessorsRecording the Stereo Track Creating an Audio CD Page Glossary
Top Page Image Contents