Compex Systems SONOSAX SX-S, SX-V Seite 17 von, Cables for Boom Operator with tbk mic transmitter

SONOSAX SX/S USER MANUAL Seite 17 von 22

To make the external slate Mic operational you will need to solder in R-7=15kOhms (R-5=49.9) and C-11=22pF remove R-10 on the extension module operator board. Unsolder the internal mic on Connectors J-10 & J-11.

Then connect J-12 to the Bantam jack. Make sure that Jumper 2 is in position 2,3.

NOTE: The internal Slate Mic is deactivated by this procedure.

SX-S10 only: Remove the unused wire on the Bantam connector.

7.4 Y Cables for Boom Operator with tbk mic transmitter.

Click here for DIAGRAMof "Y" Cable

Internal connections of the Boom-Box (022260)

Click here for BOOM BOX Wiring Diagram

	860162		860179			860141
Pin No		Cable	Pin No	Cable	Pin
			1	White	Tip	White
			2	White	Ring	Red
1	GND	Black	3	White	GND	GND
3	White	Black	4
2	Red	Black	5
			6

922110 External cable between SX-S extension module and SX-S extension box

Click here for MALE and FEMALE Socket Wiring

Pin No	Pair No	Cable	Designation
12	4	Shield	GND
11	4	White	-12V
10	4	Yellow	+12V
9	3	Orange	Guest
8	3	White	Roll
7	3	Shield	12V micro
6	2	Red	Right from Ext. Box
5	2	White	Left from Ext. Box
4	2	Shield	GND from Ext. Box
3	1	Brown	Right to Ext. Box
2	1	White	Left to Ext. Box
1	1	Shield	GND to Ext. Box

RETURN TO TABLE OF CONTENTS

file://D:\Z_Library\Webcopy\sonosax\SXS\sxsume.html 26.08.2004