Behringer MX9000 user manual MIX-B master, Mix-B

Page 19

a) Aux returns 1 and 2

Aux returns 1 and 2 have full subgroup routing matrices to enable returning FX to be sent to tape, plus main mix bus assignment. The functions for aux return 1 (mirrored by aux return 2) are: ROUTING (S49/50/51/52/

53)LEVEL (P49), BALANCE (P51) and SOLO (S54). LEVEL controls the amount of signal being blended into the mix or a subgroup, while BALANCE controls the relative amounts of L and R processed signal. We doubt if you’ll often want to adjust BALANCE away from center.

+As always, there are exceptions to -above rule. Some short stereo delay effects (say 30 ms to L, 50 ms to right) cause a psychoacoustic effect where the earlier delay seems louder. A similar effect is noticeable when harmonizing in stereo: a slight pitch shift upwards will seem louder than one that goes down. In both cases use the BALANCE control (P51) to compensate.

+When carrying out the above mentioned information, or any other stereo imaging exercise, don’t just rely on the control room monitors. Get a pair of headphones and listen in stereo and in reverse stereo, to allow for any hearing discrepancy between your ears.

b) Aux returns 3 to 6

And so to aux returns 3 through 6. These too have a routing matrix (S55 to 58 for aux return 3), but this time it is designed to facilitate monitoring rather than recording. The options are MAIN (L/ R) MIX, and PHONES 1/2. Gain pots and solo switches complete the picture.

c) SOLO

Below each column of aux returns lies a local solo LED (L61 & L74). These illuminate whenever a SOLO button in the column above is pressed.

There is no absolute reason why the send from aux 1 should feed into a processor whose outputs are sent to the aux return 1. The processor could just as easily be patched into the aux return 3, or even a pair of channels. For many purposes, however, it is sensible to set up a default patch where the aux outputs and inputs correspond. It is logical to put your premier FX units into the aux 1 and aux 2 loops, since these returns enable you to record to tape without re-patching.

+An exception to the above is when recording a group of performers live to multitrack. (See section 16.3 “Wet monitoring”).

+Sometimes an engineer wants to narrow the stereo width of a reverb field. To do this you will have to come back on either A or B-channels, which have full PAN facilities.

6.2 MIX-B master

Fig. 6.3: Mix-B

Only two controls occupy the MIX-B master (fig. 6.3). P48 offers the standard EURODESK gain of up to +15 dB. S48 is crucial: it routes the MIX-B bus output into the main mix bus. MIX-B can have three basic functions:

It can act as an entirely separate mixer-within-a-mixer to provide a completely separate mix (S48 UP, S23 DOWN). (See also section 17.)

It can act as an additional stereo aux feed to FX as well as a pre fader monitoring aid during mixdown (S48 UP, S23 DOWN).

19

Image 19
Contents Eurodesk MX9000 Detailed Safety Instructions Safety InstructionsForeword Table of Content Track Recording with 2 Samplers Eurodesk Overview ManualMetering PSU Power Supply UnitINPUT/OUTPUT Channel Input switchingChannel strip Channel input switching architecture Input gain settingAux sends Main equalizerAux sends Routing and mutingRouting ChannelB-channel InsertsSubgroups Subgroup and Direct OutputsStereo subgroup channel schematic Direct outputs Master PanelAux masters Aux sends Stereo aux returns Mix-B MIX-B masterMonitoring MonitoringPhones HeadphonesTalkback PFL/SOLORear panel ConnectionsPower supply unit connector Subgroup inserts Main balanced outputs 10 MIX-B operating level switch and phantom power switch Plug soldering guide Page Normalized bay PatchfieldPatchfield Example of patchbay configurations Wiring for bay 8 for advanced wiring scheme refer to section Looming problemsEqualization Gain Optimization Unbalanced Lines Impedances and TuningSTART-UP Channel setting up procedureDesk/tape setting up procedures Track Midi SUITE/DANCE Production Studio Sends Auxless headphones mixReturns Slightly more complicated auxless headphones mixRecording Track Recording with 2 SamplersLining up record/sample inputs MixdownProfessional 24-TRACK Studio HeadphonesTab .1 Channel assignment Live P.A. with 2-TRACK Recording Very tricky headphonesWet monitoring Tab .1 Channel assignments 2-track Live Concert with 24-TRACK Recording Tab .2 Front/rear/stage monitors routing Alignment Expanding the Eurodesk MX9000Timecode ConnectionsSequencing Live BouncingModifications INPUT/OUTPUT ConfigurationMIX-B source post fader Aux sends post EQLED meters pre fader Specifications DBr ref. +4 dBu, 24 chs. assigned input B & set @ unity gain § 1 Warranty CARD/ONLINE Registration WarrantyPage
Related manuals
Manual 57 pages 34.68 Kb